Home › Steering › POWER ASSIST SYSTEMS › POWER STEERING SYSTEM
RM37H0E _55 Steering _097126 POWER ASSIST SYSTEMS _0454879 POWER STEERING SYSTEM D

POWER ASSIST SYSTEMS  POWER STEERING SYSTEM  UTILITY  


POWER STEERING ECU INITIAL SETTING


NOTICE:

Perform Power Steering ECU Initial Setting when the rack and pinion power steering gear assembly is replaced.


HINT:

When Power Steering ECU Initial Setting is executed, assist map writing are performed.


a.

Perform Power Steering ECU Initial Setting according to the instructions on the GTS screen.

Chassis > EMPS > Utility
Tester Display
Power Steering ECU Initial Setting
50005 405 4550

b.

Clear the vehicle control history (RoB).

Click hereSteering>POWER ASSIST SYSTEMS>POWER STEERING SYSTEM>VEHICLE CONTROL HISTORY


c.

Turn the ignition switch off.


d.

Turn the ignition switch to ON.


e.

Check that vehicle control history (RoB) is not output.

HINT:

If vehicle control history (RoB) is not output, the procedure has been completed normally.