The image signals sent from the inner mirror camera assembly are input to the inner rear view mirror assembly via the vehicle wire harness and then displayed on the screen.
Disconnect the H25 inner rear view mirror assembly connector.
Disconnect the K11 inner mirror camera assembly connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
|
Click Location & Routing(H25,K11)Location & Routingewd_type=routing;type=c,c;code=H25,K11 Click Connector(H25)Body>No. 1 Roof Wire>Inner Rear View Mirror Assemblyewd_type=component;type=c;code=H25;pinno=1,2,4,3,5 Click Connector(K11)Body>No. 1 Back Door Wire>Inner Mirror Camera Assemblyewd_type=component;type=c;code=K11;pinno=3,1,4,2,5 |
||
| H25-1 (CEG) - K11-3 (CEG) | Always | Below 1 Ω |
| H25-2 (CEB+) - K11-1 (CEB+) | Always | Below 1 Ω |
| H25-4 (CEV+) - K11-4 (CEV+) | Always | Below 1 Ω |
| H25-3 (CEV-) - K11-2 (CEV-) | Always | Below 1 Ω |
| H25-5 (SGND) - K11-5 (SGND) | Always | Below 1 Ω |
| H25-1 (CEG) or K11-3 (CEG) - Body ground | Always | 10 kΩ or higher |
| H25-2 (CEB+) or K11-1 (CEB+) - Body ground | Always | 10 kΩ or higher |
| H25-4 (CEV+) or K11-4 (CEV+) - Body ground | Always | 10 kΩ or higher |
| H25-3 (CEV-) or K11-2 (CEV-) - Body ground | Always | 10 kΩ or higher |
| H25-5 (SGND) - K11-5 (SGND) - Body ground | Always | 10 kΩ or higher |
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Disconnect the K11 inner mirror camera assembly connector.
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
|---|---|---|
|
Click Location & Routing(K11)Location & Routingewd_type=routing;type=c;code=K11 Click Connector(K11)Body>No. 1 Back Door Wire>Inner Mirror Camera Assemblyewd_type=component;type=c;code=K11;pinno=1,3 |
||
| K11-1 (CEB+) - K11-3 (CEG) | Ignition switch ON | 5.5 V or higher |
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Temporarily replace the inner mirror camera assembly with a new or known good one.
Click hereVehicle Interior>MIRROR (INT)>INNER MIRROR MONITOR CAMERA>REMOVAL
Check that the digital rear-view mirror system is operating normally.
The digital rear-view mirror system is operating normally.
| Proceed to |
|---|
| OK |
| NG |
OK
NG