| *1 | TELEVISION CAMERA COVER | - | - |
| ● | Non-reusable part | - | - |
The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during inner mirror camera assembly removal/installation are shown below.
76801A
1.REMOVE LUGGAGE COMPARTMENT DOOR OUTSIDE GARNISH SUB-ASSEMBLY
85373R
3.REMOVE REAR WASHER (FROM JOINT TO NOZZLE) HOSE
867C0
5.REMOVE INNER MIRROR CAMERA ASSEMBLY
|
Remove in this Direction | - | - |
Remove the 4 screws and television camera cover.
Using a T6 "TORX" socket wrench, remove the 2 "TORX" screws.
Remove the inner mirror camera assembly as shown in the illustration.