Home › Audio / Visual / Telematics › PARK ASSIST / MONITORING › PARKING ASSIST MONITOR SYSTEM
RM37H0E _56 Audio / Visual / Telematics _095293 PARK ASSIST / MONITORING _0455113 PARKING ASSIST MONITOR SYSTEM C

PARK ASSIST / MONITORING  PARKING ASSIST MONITOR SYSTEM  C1625  Open or Short in Steering Angle Sensor +B  


DESCRIPTION

This DTC is stored if the television camera assembly receives a signal via CAN communication from the steering sensor that indicates a power supply problem.

DTC No. Detection Item DTC Detection Condition Trouble Area DTC Output from Priority
C1625 Open or Short in Steering Angle Sensor +B Open or short in steering sensor power source
·

Harness or connector

·

Steering sensor


Rear Camera A

WIRING DIAGRAM

C402935E11
5.323,2.063 6.802,2.49 1.479,0.427 10 false Rear Television Camera Assembly 3.365,0.615 3.688,0.792 0.323,0.177 10 false BAT 3.375,1.021 3.625,1.198 0.25,0.177 10 false IG1 3.365,1.417 3.719,1.615 0.354,0.198 10 false ESS 0.323,1 1.792,1.208 1.469,0.208 10 false from IG1 D NO.1 Relay 0.396,0.615 2.073,0.813 1.677,0.198 10 false from Auxiliary Battery 0.635,2.323 2.313,2.521 1.677,0.198 10 false : CAN Communication Line 3.167,0.531 3.375,0.729 0.208,0.198 10 false 4 3.156,0.927 3.448,1.125 0.292,0.198 10 false 9 3.156,1.323 3.448,1.521 0.292,0.198 10 false 6 3.417,1.865 3.708,2.031 0.292,0.167 10 false D34 3.417,2.021 5.271,2.302 1.854,0.281 10 false Steering Sensor 2.323,1.198 3.115,1.406 0.792,0.208 10 false IG1 D NO.3 2.167,0.802 3.146,1.01 0.979,0.208 10 false MPX-B D NO.1

CAUTION / NOTICE / HINT

NOTICE:
·

Inspect the fuses for circuits related to this system before performing the following procedure.

·

When the "!" mark is displayed on the display after disconnecting the cable from the negative (-) auxiliary battery terminal, correct the steering angle neutral point.

Click hereAudio / Visual / Telematics>PARK ASSIST / MONITORING>PARKING ASSIST MONITOR SYSTEM>INITIALIZATION

·

Depending on the parts that are replaced or operations that are performed during vehicle inspection or maintenance, calibration of other systems as well as the parking assist monitor system may be needed.

Click hereAudio / Visual / Telematics>PARK ASSIST / MONITORING>PARKING ASSIST MONITOR SYSTEM>CALIBRATION

·

The vehicle is equipped with a Supplemental Restraint System (SRS) which includes components such as airbags. Before servicing (including removal or installation of parts), be sure to read the precaution for Supplemental Restraint System.

Click hereVehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM>PRECAUTION

·

After the ignition switch is turned off, there may be a waiting time before disconnecting the negative (-) auxiliary battery terminal.

Click hereGeneral>SETUP>WHEN DISCONNECTING OR RECONNECTING BATTERY TERMINAL>BEFORE DISCONNECTING BATTERY

·

When disconnecting and reconnecting the auxiliary battery

Click hereGeneral>SETUP>WHEN DISCONNECTING OR RECONNECTING BATTERY TERMINAL>WORK PROCEDURE

HINT:

When disconnecting and reconnecting the auxiliary battery, there is an automatic learning function that completes learning when the respective system is used.

Click hereGeneral>SETUP>WHEN DISCONNECTING OR RECONNECTING BATTERY TERMINAL>AUTOMATIC LEARNING CHART




PROCEDURE

1.CHECK HARNESS AND CONNECTOR (STEERING SENSOR POWER SOURCE AND BODY GROUND)

Pre-procedure1

a.

Disconnect the steering sensor connector.


Procedure1

b.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition

Click Location & Routing(D34)Location & Routing

Click Connector(D34)Instrument Panel>Instrument Panel Wire>Steering Sensor

D34-6 (ESS) - Body ground Always Below 1 Ω



c.

Measure the voltage according to the value(s) in the table below.

Standard Voltage:
Tester Connection Switch Condition Specified Condition

Click Location & Routing(D34)Location & Routing

Click Connector(D34)Instrument Panel>Instrument Panel Wire>Steering Sensor

D34-9 (IG1) - D34-6 (ESS) Ignition switch ON 11 to 14 V
D34-4 (BAT) - D34-6 (ESS) Ignition switch off 11 to 14 V



Result:
Proceed to
OK
NG


Post-procedure1

d.

None



OK

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR