Home › Audio / Visual / Telematics › PARK ASSIST / MONITORING › PARKING ASSIST MONITOR SYSTEM
RM37H0E _56 Audio / Visual / Telematics _095293 PARK ASSIST / MONITORING _0455113 PARKING ASSIST MONITOR SYSTEM C

PARK ASSIST / MONITORING  PARKING ASSIST MONITOR SYSTEM  U1000  CAN Communication Failure (Message Registry)  


DESCRIPTION

This DTC is stored when the rear television camera assembly judges that it has an internal CAN malfunction.

DTC No. Detection Item DTC Detection Condition Trouble Area DTC Output from Priority
U1000 CAN Communication Failure (Message Registry) CAN communication failure (message registry) Rear television camera assembly Rear Camera A

CAUTION / NOTICE / HINT

NOTICE:
·

If the cable was disconnected from and reconnected to the negative (-) auxiliary battery terminal, the estimated course lines may not be displayed on the image of the area behind the vehicle. In this case, perform "Correct the Steering Angle Neutral Point".

Click hereAudio / Visual / Telematics>PARK ASSIST / MONITORING>PARKING ASSIST MONITOR SYSTEM>INITIALIZATION

·

Depending on the parts that are replaced or operations that are performed during vehicle inspection or maintenance, calibration of other systems as well as the parking assist monitor system may be needed.

Click hereAudio / Visual / Telematics>PARK ASSIST / MONITORING>PARKING ASSIST MONITOR SYSTEM>CALIBRATION



PROCEDURE

1.CLEAR DTC
a.

Clear the DTCs.

Chassis > Rear Camera > Clear DTCs
50002 85

Result:
Proceed to
NEXT



NEXT

2.CHECK DTC OUTPUT
2.CHECK DTC OUTPUT
a.

Recheck for DTCs and check that no DTCs are output.

Chassis > Rear Camera > Trouble Codes
50001 85
HINT:
·

If DTC U1000 is not output again when rechecking for DTCs, it may have been stored due to a temporary CAN malfunction.

·

If DTC U1000 is output frequently, duplicate the problem symptoms and perform the inspection again, even if the DTC was not output when rechecking for DTCs.

Click hereGeneral>INTRODUCTION>HOW TO TROUBLESHOOT ECU CONTROLLED SYSTEMS>HOW TO PROCEED WITH TROUBLESHOOTING




Result:
Result Proceed to
U1000 is not output A
U1000 is output B



A

B