| *A | w/o Digital Inner Mirror | *B | w/ Digital Inner Mirror |
| *1 | TELEVISION CAMERA COVER | *2 | REAR TELEVISION CAMERA ASSEMBLY |
| ● | Non-reusable part | - | - |
The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed, installed or replaced during the television camera assembly removal/installation are shown below.
76801A
1.REMOVE LUGGAGE COMPARTMENT DOOR OUTSIDE GARNISH SUB-ASSEMBLY
86790D
2.REMOVE REAR TELEVISION CAMERA ASSEMBLY (w/o Digital Inner Mirror)
|
|
|
Remove in this Direction | - | - |
867A0
3.REMOVE TELEVISION AND INNER REAR VIEW MIRROR CAMERA ASSEMBLY (w/ Digital Inner Mirror)
|
|
|
Remove in this Direction | - | - |
Disconnect the camera cleaner hose.
Using clip remover, detach the clamp.
Disconnect the 2 connectors.
Detach the claw and guide and remove the television and inner rear view mirror camera assembly the direction of the arrow shown in the illustration.
85373R
4.REMOVE REAR WASHER (FROM JOINT TO NOZZLE) HOSE (w/ Digital Inner Mirror)
5.REMOVE TELEVISION CAMERA SEAL
|
|
867F0A
7.REMOVE NO. 1 CAMERA CLEANER NOZZLE ASSEMBLY (w/ Digital Inner Mirror)
867F0B
8.REMOVE NO. 2 CAMERA CLEANER NOZZLE ASSEMBLY (w/ Digital Inner Mirror)