The blind spot monitor sensor receives yaw rate signals from the yaw rate sensor via CAN communication.
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area | DTC Output from | Priority |
|---|---|---|---|---|---|
| C1A46 | Yaw Rate Sensor | A fail flag is transmitted from the yaw rate sensor | ·
Electronically controlled brake system ·
Blind spot monitor sensor RH |
Blind Spot Monitor Master | B |
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area | DTC Output from | Priority |
|---|---|---|---|---|---|
| C1A46 | Yaw Rate Sensor | A fail flag is transmitted from the yaw rate sensor | ·
Electronically controlled brake system ·
Blind spot monitor sensor LH |
Blind Spot Monitor Slave | B |
When checking for DTCs, make sure that the blind spot monitor system is turned on.
Check for electronically controlled brake system DTCs.
| Result | Proceed to |
|---|---|
| DTCs are not output | A |
| DTCs are output | B |
A
B
Clear the DTCs.
| Proceed to |
|---|
| NEXT |
NEXT
Clear the DTCs.
| Proceed to |
|---|
| NEXT |
NEXT
Check for DTCs.
| Result | Proceed to |
|---|---|
| C1A46 is not output | A |
| C1A46 is output | B |
A
B
Check for DTCs.
| Result | Proceed to |
|---|---|
| C1A46 is not output | A |
| C1A46 is output | B |
A
Click hereGeneral>INTRODUCTION>HOW TO TROUBLESHOOT ECU CONTROLLED SYSTEMS>HOW TO PROCEED WITH TROUBLESHOOTING
B