Home › Audio / Visual / Telematics › PARK ASSIST / MONITORING › BLIND SPOT MONITOR SENSOR
RM37H0E _56 Audio / Visual / Telematics _095293 PARK ASSIST / MONITORING _0448135 BLIND SPOT MONITOR SENSOR A

PARK ASSIST / MONITORING  BLIND SPOT MONITOR SENSOR  REMOVAL  


CAUTION / NOTICE / HINT

COMPONENTS (REMOVAL)
B594856N02
1.313,0.625 1.531,0.625 1.531,0.625 1.875,1.031 false 3.521,0.49 4.177,0.49 false 4.469,1.26 4.688,1.26 4.688,1.26 5.188,1.885 false 1.104,0.51 1.385,0.865 0.281,0.354 18 false 2 3.323,0.354 3.604,0.708 0.281,0.354 18 false 3 4.271,1.135 4.552,1.49 0.281,0.354 18 false 1 1.469,1.573 1.927,1.771 0.458,0.198 10 false x 3 4.875,0.5 5.333,0.698 0.458,0.198 10 false x 3

Procedure Part Name Code
Z101186

Z101188

Z101187

1 REAR BUMPER ASSEMBLY - - - -
2 BLIND SPOT MONITOR SENSOR LH 88172 - - -
3 BLIND SPOT MONITOR SENSOR RH 88162 - - -

CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed, installed or replaced during blind spot monitor sensor removal/installation are shown below.

Necessary Procedures After Parts Removed/Installed/Replaced
Replaced Part or Performed Procedures Necessary Procedures Effect/Inoperative Function When Necessary Procedures are not Performed Link
Rear bumper assembly (Including removal and installation)
·

Measurement of ultrasonic sensor detection angle

·

Ultrasonic sensor detection angle registration


·

TOYOTA Parking assist- sensor system

·

Parking support brake system

·

Advanced park


w/ Advanced Park:
(Click here)
w/o Advanced Park:
(Click here)
Blind spot monitor sensor Blind spot monitor beam axis confirmation
·

Parking support brake system

·

Blind spot monitor system


(Click here)

PROCEDURE

Hide 1.REMOVE REAR BUMPER ASSEMBLY

Hide 88172 2.REMOVE BLIND SPOT MONITOR SENSOR LH

a.
B599543C01
0,0 0,0 false
V100135

Nut
V100136

Connector



Hide 88162 3.REMOVE BLIND SPOT MONITOR SENSOR RH

a.

Use the same procedure described for the LH side.