| *A | for Manual Tilt and Manual Telescopic Steering Column | *B | for Power Tilt and Power Telescopic Steering Column |
Use the same procedure for the RH and LH sides.
The procedure listed below is for the RH side.
84650
1.INSTALL WINDSHIELD WIPER SWITCH ASSEMBLY
45286B
2.INSTALL UPPER STEERING COLUMN COVER
45287
3.INSTALL LOWER STEERING COLUMN COVER
|
|
|
Install in this Direction | - | - |
Push the lower steering column cover in the direction of the arrow shown in the illustration to install it, taking care not to catch the tilt and telescopic switch.
Engage the claws.
Install the screw.
Turn the steering wheel assembly 90° to the right from the straight condition and install the screw.
Turn the steering wheel assembly 90° to the left from the straight condition and install the screw.
Turn the steering wheel assembly to the left and install the screw.
Turn the steering wheel assembly to the right and install the lower steering column cover with the screw.
4. CUSTOMIZE POWER TILT AND POWER TELESCOPIC STEERING COLUMN SYSTEM (for Power Tilt and Power Telescopic Steering Column)
|
|
Perform the customization settings.