Home › Brake › BRAKE (REAR) › REAR BRAKE
RM37H0E _54 Brake _097303 BRAKE (REAR) _0455483 REAR BRAKE G

BRAKE (REAR)  REAR BRAKE  INSPECTION  


PROCEDURE

Hide 1.INSPECT BRAKE CYLINDER AND PISTON

a.

Check the rear disc brake cylinder assembly bore and rear disc brake piston for rust and scoring. If necessary, replace the rear disc brake cylinder assembly and rear disc brake piston.


Hide 2.INSPECT PAD LINING THICKNESS

a.

Using a ruler, measure the rear disc brake pad lining thickness.

Standard Thickness:

13.5 mm (0.531 in.)


Minimum Thickness:

1.0 mm (0.0394 in.)


If a rear disc brake pad lining thickness is less than the minimum thickness, replace the rear disc brake pads.

Rear Disc Brake Pad Lining Thickness:
Specified Condition
1.0 mm or higher
0.0394 in. or higher



Hide 04948 3.INSPECT REAR DISC BRAKE ANTI-RATTLE SPRING

a.

Clean the No. 1 anti-rattle spring, inner anti-rattle spring and check it for deformation and cracks.


b.

When installing the No. 1 anti-rattle spring to the rear disc brake cylinder, check that the spring's force is applied to the hole pin and rear disc brake pad.


Hide 4.INSPECT DISC THICKNESS

a.
C450064C01
1.073,1.771 1.073,1.542 true 1,1.823 1.313,2.021 0.313,0.198 10 true *a
*a Micrometer


Using a micrometer, measure the rear disc thickness.

Standard Thickness:

25.0 mm (0.984 in.)


Minimum Thickness:

23.0 mm (0.906 in.)


If the rear disc thickness is less than the minimum thickness, replace the rear disc.

Rear Disc Thickness.:
Specified Condition
23.0 mm or higher
0.906 in. or higher



Hide 5.INSPECT DISC RUNOUT

a.

Inspect the rear axle hub bearing looseness and rear axle hub runout.

Click hereDrivetrain>AXLE AND DIFFERENTIAL>REAR AXLE HUB>ON-VEHICLE INSPECTION


b.

Hold the rear disc, tighten the rear disc with the 5 hub nuts.

Torque:
140 N*m (1428 kgf*cm, 103 ft.*lbf)


c.
C450065C01
2.302,0.771 2.542,0.979 2.542,0.979 2.688,0.979 true 2.771,0.906 3.01,1.115 0.24,0.208 10 true *a
*a Dial Indicator


Using a dial indicator, measure the disc runout 10 mm (0.394 in.) from the outer edge of the rear disc.

Maximum Disc Runout:

0.04 mm (0.00157 in.)


Rear Disc Runout:
Specified Condition
0.04 mm or less
0.00157 in. or less


NOTICE:

Keep the magnet of the dial indicator away from the rear axle hub and bearing assembly and rear speed sensor.


If the runout exceeds the maximum value, change the installation position of the rear disc to minimize the runout. If the runout exceeds the maximum even when the installation position is changed, replace the rear disc.


d.

Remove the 5 hub nuts and rear disc.