Home › ADAS / AD › ADVANCED DRIVER ASSISTANCE SYSTEM › PRE-COLLISION SYSTEM
RM37H0E _95 ADAS / AD _095317 ADVANCED DRIVER ASSISTANCE SYSTEM _0455731 PRE-COLLISION SYSTEM C

ADVANCED DRIVER ASSISTANCE SYSTEM  PRE-COLLISION SYSTEM  U041881  Invalid Data Received from Brake System Control Module Invalid Serial Data Received  


DESCRIPTION

·

The forward recognition camera receives signals from the No. 2 skid control ECU (brake actuator assembly) corresponding to the brake control status via the CAN communication line.

·

When a brake control system malfunction signal is received from the No. 2 skid control ECU (brake actuator assembly), the forward recognition camera outputs U041881.


DTC No. Detection Item DTC Detection Condition Trouble Area DTC Output from Priority
U041881 Invalid Data Received from Brake System Control Module Invalid Serial Data Received Once 3 seconds elapse after turning the ignition switch to ON, the forward recognition camera receives a brake control system malfunction signal from the No. 2 skid control ECU (brake actuator assembly) for approximately 1 second or more.
·

Forward recognition camera

·

Electronically controlled brake system


Pre-Collision System B

CAUTION / NOTICE / HINT

NOTICE:
·

When replacing the forward recognition camera, always replace it with a new one. If a forward recognition camera which was installed to another vehicle is used, the information stored in the forward recognition camera will not match the information from the vehicle. As a result, a DTC may be stored.

·

When the forward recognition camera is replaced with a new one, make sure to read Before Starting Adjustment, then perform optical axis alignment for the forward recognition camera and clear the vehicle control history for each system.

HINT:

Forward recognition camera axis alignment can be performed by using either One Time Recognition, Sequential Recognition or Driving Adjustment.

One Time Recognition: Click hereADAS / AD>ADVANCED DRIVER ASSISTANCE SYSTEM>FRONT CAMERA>TARGET ADJUSTMENT(ONE TIME RECOGNITION)

Sequential Recognition: Click hereADAS / AD>ADVANCED DRIVER ASSISTANCE SYSTEM>FRONT CAMERA>TARGET ADJUSTMENT(SEQUENTIAL RECOGNITION)

Driving Adjustment: Click hereADAS / AD>ADVANCED DRIVER ASSISTANCE SYSTEM>FRONT CAMERA>DRIVING ADJUSTMENT




PROCEDURE

1.CHECK ELECTRONICALLY CONTROLLED BRAKE SYSTEM
a.

Check the DTCs.

Chassis > Brake/EPB > Trouble Codes
50001 435
HINT:

If U041881 is output in the pre-collision system, electronically controlled brake system DTCs may also have been output. Check the electronically controlled brake system first.



Result:
Result Proceed to
DTCs are not output A
DTCs are output B



A

REPLACE FORWARD RECOGNITION CAMERA

B