The No. 2 skid control ECU (brake actuator assembly) sends signals such as brake request signals to the EV control ECU. If an abnormal signal is detected, the EV control ECU stores DTC P163081.
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area | DTC Output from | Priority |
|---|---|---|---|---|---|
| P163081 | Communication Error from VSC to ECM Invalid Serial Data Received | When the dynamic radar cruise control system is operating, the EV control ECU detects abnormal data sent from the No. 2 skid control ECU (brake actuator assembly) for 1 second or more. | ·
Electronically controlled brake system ·
EV control ECU |
Radar Cruise1 | B |
Before replacing the EV control ECU, refer to Service Bulletin.
Check for electronically controlled brake system DTCs.
| Result | Proceed to |
|---|---|
| DTCs are not output | A |
| DTCs are output | B |
A
B
Pre-procedure1
None
Procedure1
Clear the DTCs.
| Proceed to |
|---|
| NEXT |
Post-procedure1
None
NEXT
Pre-procedure1
Make sure that the DTC detection conditions are met.
If the detection conditions are not met, the system cannot detect the malfunction.
Procedure1
Check for DTCs.
| Result | Proceed to |
|---|---|
| P163081 is not output | A |
| P163081 is output | B |
Post-procedure1
None
A
Click hereGeneral>INTRODUCTION>HOW TO TROUBLESHOOT ECU CONTROLLED SYSTEMS>HOW TO PROCEED WITH TROUBLESHOOTING
B