Home › ADAS / AD › ADVANCED DRIVER ASSISTANCE SYSTEM › DYNAMIC RADAR CRUISE CONTROL SYSTEM
RM37H0E _95 ADAS / AD _095317 ADVANCED DRIVER ASSISTANCE SYSTEM _0455732 DYNAMIC RADAR CRUISE CONTROL SYSTEM C

ADVANCED DRIVER ASSISTANCE SYSTEM  DYNAMIC RADAR CRUISE CONTROL SYSTEM  U031851  Software Incompatibility with Brake System Control Module Not Programmed  U032251  Software Incompatibility with Body Control Module Not Programmed  


DESCRIPTION

·

If the forward recognition camera cannot verify the vehicle information sent from the No. 2 skid control ECU (brake actuator assembly), the forward recognition camera stores DTC U031851.

·

If the forward recognition camera cannot verify the vehicle information sent from the main body ECU (multiplex network body ECU), the forward recognition camera stores DTC U032251.


DTC No. Detection Item DTC Detection Condition Trouble Area DTC Output from Priority
U031851 Software Incompatibility with Brake System Control Module Not Programmed The vehicle information sent from the No. 2 skid control ECU (brake actuator assembly) cannot be verified by the forward recognition camera. Forward recognition camera Radar Cruise2 A
U032251 Software Incompatibility with Body Control Module Not Programmed The vehicle information sent from the main body ECU (multiplex network body ECU) cannot be verified by the forward recognition camera. Forward recognition camera Radar Cruise2 A

CAUTION / NOTICE / HINT

NOTICE:
·

When replacing the forward recognition camera, replace it with a new one. If a forward recognition camera which was installed to another vehicle is used, the information stored in the forward recognition camera will not match the information from the vehicle and a DTC may be stored.

·

When the forward recognition camera is replaced with a new one, make sure to read Before Starting Adjustment, then perform optical axis alignment for the forward recognition camera and clear the vehicle control history for each system.

HINT:

Forward recognition camera axis alignment can be performed by using either One Time Recognition, Sequential Recognition or Driving Adjustment.

One Time Recognition: Click hereADAS / AD>ADVANCED DRIVER ASSISTANCE SYSTEM>FRONT CAMERA>TARGET ADJUSTMENT(ONE TIME RECOGNITION)

Sequential Recognition: Click hereADAS / AD>ADVANCED DRIVER ASSISTANCE SYSTEM>FRONT CAMERA>TARGET ADJUSTMENT(SEQUENTIAL RECOGNITION)

Driving Adjustment: Click hereADAS / AD>ADVANCED DRIVER ASSISTANCE SYSTEM>FRONT CAMERA>DRIVING ADJUSTMENT




PROCEDURE

1.REPLACE FRONT CAMERA SYSTEM

Pre-procedure1

a.

None


Procedure1

b.

Replace the forward recognition camera with a new one.

HINT:

Click hereADAS / AD>ADVANCED DRIVER ASSISTANCE SYSTEM>FRONT CAMERA>REMOVAL


Result:
Proceed to
NEXT



Post-procedure1

c.

Perform forward recognition camera adjustment.

HINT:

Forward recognition camera axis alignment can be performed by using either One Time Recognition, Sequential Recognition or Driving Adjustment.

One Time Recognition: Click hereADAS / AD>ADVANCED DRIVER ASSISTANCE SYSTEM>FRONT CAMERA>TARGET ADJUSTMENT(ONE TIME RECOGNITION)

Sequential Recognition: Click hereADAS / AD>ADVANCED DRIVER ASSISTANCE SYSTEM>FRONT CAMERA>TARGET ADJUSTMENT(SEQUENTIAL RECOGNITION)

Driving Adjustment: Click hereADAS / AD>ADVANCED DRIVER ASSISTANCE SYSTEM>FRONT CAMERA>DRIVING ADJUSTMENT




NEXT

2.CLEAR DTC (Radar Cruise2)
2.CLEAR DTC (Radar Cruise2)
a.

Clear the DTCs.

Powertrain > Radar Cruise2 > Clear DTCs
50002 426

Result:
Proceed to
NEXT



NEXT

END