Home › ADAS / AD › ADVANCED DRIVER ASSISTANCE SYSTEM › DYNAMIC RADAR CRUISE CONTROL SYSTEM
RM37H0E _95 ADAS / AD _095317 ADVANCED DRIVER ASSISTANCE SYSTEM _0455732 DYNAMIC RADAR CRUISE CONTROL SYSTEM C

ADVANCED DRIVER ASSISTANCE SYSTEM  DYNAMIC RADAR CRUISE CONTROL SYSTEM  U031857  Software Incompatibility with Brake System Control Module Invalid/Incompatible Software Component  


DESCRIPTION

If the vehicle information stored in the forward recognition camera does not match the vehicle information sent from the No. 2 skid control ECU (brake actuator assembly), the forward recognition camera stores DTC U031857.

DTC No. Detection Item DTC Detection Condition Trouble Area DTC Output from Priority
U031857 Software Incompatibility with Brake System Control Module Invalid/Incompatible Software Component The vehicle information sent from the No. 2 skid control ECU (brake actuator assembly) does not match that stored in the forward recognition camera.
·

Electronically controlled brake system

·

Forward recognition camera


Radar Cruise2 A

CAUTION / NOTICE / HINT

NOTICE:
·

When replacing the forward recognition camera, replace it with a new one. If a forward recognition camera which was installed to another vehicle is used, the information stored in the forward recognition camera will not match the information from the vehicle and a DTC may be stored.

·

When the forward recognition camera is replaced with a new one, make sure to read Before Starting Adjustment, then perform optical axis alignment for the forward recognition camera and clear the vehicle control history for each system.

HINT:

Forward recognition camera axis alignment can be performed by using either One Time Recognition, Sequential Recognition or Driving Adjustment.

One Time Recognition: Click hereADAS / AD>ADVANCED DRIVER ASSISTANCE SYSTEM>FRONT CAMERA>TARGET ADJUSTMENT(ONE TIME RECOGNITION)

Sequential Recognition: Click hereADAS / AD>ADVANCED DRIVER ASSISTANCE SYSTEM>FRONT CAMERA>TARGET ADJUSTMENT(SEQUENTIAL RECOGNITION)

Driving Adjustment: Click hereADAS / AD>ADVANCED DRIVER ASSISTANCE SYSTEM>FRONT CAMERA>DRIVING ADJUSTMENT




PROCEDURE

1.CHECK FOR DTCs (ELECTRONICALLY CONTROLLED BRAKE SYSTEM)
a.

Check for electronically controlled brake system DTCs.

Chassis > Brake/EPB > Trouble Codes
50001 435

Result:
Result Proceed to
DTCs are not output A
DTCs are output B



A

REPLACE FORWARD RECOGNITION CAMERA

B