| Procedure | Part Name Code |
|
|
|
|
|---|---|---|---|---|---|
| 1 | FRONT STABILIZER BAR | 48811 | ( )
|
- | - |
| 2 | FRONT STABILIZER LINK ASSEMBLY LH | 48810 | ( )
|
- | - |
| 3 | FRONT STABILIZER LINK ASSEMBLY RH | 48820B | - | - | - |
|
Tightening torque for "Major areas involving basic vehicle performance such as moving/turning/stopping": N*m (kgf*cm, ft.*lbf) | - | - |
| Procedure | Part Name Code |
|
|
|
|
|---|---|---|---|---|---|
| 4 | FRONT COMPARTMEMT UNDER COVER ASSEMBLY | 51420A | - | - | - |
| 5 | FRONT LOWER SUSPENSION MEMBER PROTECTOR | 51219 | - | - | - |
| 6 | FRONT COMPARTMENT UNDER COVER | 51441N | - | - | - |
| 7 | FRONT WHEEL | - | - | - | - |
|
N*m (kgf*cm, ft.*lbf): Specified torque | ● | Non-reusable part |
| ★ | Precoated part | - | - |
48811
1.INSTALL FRONT STABILIZER BAR
Install the front stabilizer bar with the 4 bolts.
Temporarily tighten the bolt (A), and then fully tighten the 4 bolts in the order of (B), (C), (D), and (A).
48810
2.INSTALL FRONT STABILIZER LINK ASSEMBLY LH
Install the front stabilizer link assembly LH to the lower No. 2 suspension arm assembly LH and front stabilizer bar with the 2 nuts.
If the ball joint turns together with the nut, use a 8 mm hexagon wrench to hold the stud bolt.
48820B
3.INSTALL FRONT STABILIZER LINK ASSEMBLY RH
Perform the same procedure as for the LH side.
51420A
4.INSTALL FRONT COMPARTMEMT UNDER COVER ASSEMBLY
51219
5.INSTALL FRONT LOWER SUSPENSION MEMBER PROTECTOR
51441N
6.INSTALL FRONT COMPARTMENT UNDER COVER
7.INSTALL FRONT WHEEL