Home › Vehicle Interior › SEAT › SEAT HEATER SYSTEM
RM37H0E _58 Vehicle Interior _095292 SEAT _0457025 SEAT HEATER SYSTEM C

SEAT  SEAT HEATER SYSTEM  B14C2  Rear Right Seat Heat Sensor Circuit  


DESCRIPTION

Output to the rear seat cushion heater temperature sensor stops if one of the following occurs: 1) the temperature sensor is open or shorted; or 2) the temperature sensor is damaged and its output value does not change.

DTC No. Detection Item DTC Detection Condition Trouble Area DTC Output from Priority
B14C2 Rear Right Seat Heat Sensor Circuit Seat heater temperature sensor malfunction
·

Air conditioning amplifier assembly

·

Seatback heater assembly RH

·

Seat cushion heater assembly RH

·

Harness or connector


Air Conditioner A

WIRING DIAGRAM

E396783E05
0.281,1.958 1.844,2.552 1.563,0.594 10 false Air Conditioning Amplifier Assembly 3.594,1.938 5.01,2.646 1.417,0.708 10 false Seatback Heater Assembly RH 5.458,1.969 6.885,2.604 1.427,0.635 10 false Seat Cushion Heater Assembly RH 1.229,0.969 1.656,1.115 0.427,0.146 10 false TFAR 1.354,1.479 1.781,1.625 0.427,0.146 10 false SG 1.802,0.729 2.073,0.885 0.271,0.156 10 false 5 1.75,1.469 2.146,1.698 0.396,0.229 10 false D78 1.75,0.958 2.094,1.146 0.344,0.188 10 false D78 1.792,1.25 2.063,1.406 0.271,0.156 10 false 19 3.281,0.958 3.552,1.115 0.271,0.156 10 false M6 3.26,1.469 3.625,1.74 0.365,0.271 10 false M6 3.302,0.719 3.479,0.917 0.177,0.198 10 false 2 3.313,1.25 3.521,1.469 0.208,0.219 10 false 3 5.167,0.958 5.385,1.115 0.219,0.156 10 false A 5.167,1.479 5.385,1.635 0.219,0.156 10 false A 5.177,0.729 5.333,0.896 0.156,0.167 10 false 4 5.177,1.24 5.333,1.406 0.156,0.167 10 false 5

PROCEDURE

1.CLEAR DTC
a.

Clear the DTCs.

Body Electrical > Air Conditioner > Clear DTCs
50002 121

Result:
Proceed to
NEXT



NEXT

2.CHECK FOR DTC
2.CHECK FOR DTC
a.

Check for DTCs.

Body Electrical > Air Conditioner > Trouble Codes
50001 121

Result:
Result Proceed to
B14C2 is not output A
B14C2 is output B



A

B

3.CHECK HARNESS AND CONNECTOR (AIR CONDITIONING AMPLIFIER ASSEMBLY - SEATBACK HEATER ASSEMBLY RH)
3.CHECK HARNESS AND CONNECTOR (AIR CONDITIONING AMPLIFIER ASSEMBLY - SEATBACK HEATER ASSEMBLY RH)

Pre-procedure1

a.

Disconnect the D78 air conditioning amplifier assembly connectors.


b.

Disconnect the M6 seatback heater assembly RH connector.


Procedure1

a.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition

Click Location & Routing(D78,M6)Location & Routing

Click Connector(D78)Instrument Panel>Instrument Panel Wire>Air Conditioning Amplifier Assembly

Click Connector(M6)Seat>No. 1 Rear Seat Wire / No. 2 Rear Seat Wire>Rear Seat Heater Assembly RH

D78-5 (TFAR) - M6-2 Always Below 1 Ω
D78-5 (TFAR) or M6-2 - Body ground Always 10 kΩ or higher
D78-19 (SG) - M6-3 Always Below 1 Ω
D78-19 (SG) or M6-3 - Body ground Always 10 kΩ or higher


Result:
Proceed to
OK
NG



Post-procedure1

a.

None



OK

4.INSPECT SEAT CUSHION HEATER ASSEMBLY RH

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR

4.INSPECT SEAT CUSHION HEATER ASSEMBLY RH

OK

5.CHECK SEATBACK HEATER ASSEMBLY RH

NG

REPLACE SEAT CUSHION HEATER ASSEMBLY RH

5.CHECK SEATBACK HEATER ASSEMBLY RH

Pre-procedure1

a.

Disconnect the M6 seatback heater assembly RH connector.


b.

Disconnect the seat cushion heater assembly RH connector.


Procedure1

a.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition

Click Location & Routing(M6)Location & Routing

Click Connector(M6)Seat>No. 1 Rear Seat Wire / No. 2 Rear Seat Wire>Rear Seat Heater Assembly RH

M6-2 - A-4 Always Below 1 Ω
M6-2 or A-4 - Body ground Always 10 kΩ or higher
M6-3 - A-5 Always Below 1 Ω
M6-3 or A-5 - Body ground Always 10 kΩ or higher


Result:
Proceed to
OK
NG



Post-procedure1

a.

None



OK

REPLACE AIR CONDITIONING AMPLIFIER ASSEMBLY

NG

REPLACE SEATBACK HEATER ASSEMBLY RH