Home › Vehicle Interior › SEAT › SEAT HEATER SYSTEM
RM37H0E _58 Vehicle Interior _095292 SEAT _0457025 SEAT HEATER SYSTEM C

SEAT  SEAT HEATER SYSTEM  B14C3  Rear Left Seat Heat Sensor Circuit  


DESCRIPTION

Output to the rear seat cushion heater temperature sensor stops if one of the following occurs: 1) the temperature sensor is open or shorted; or 2) the temperature sensor is damaged and its output value does not change.

DTC No. Detection Item DTC Detection Condition Trouble Area DTC Output from Priority
B14C3 Rear Left Seat Heat Sensor Circuit Seat heater temperature sensor malfunction
·

Air conditioning amplifier assembly

·

Seatback heater assembly LH

·

Seat cushion heater assembly LH

·

Harness or connector


Air Conditioner A

WIRING DIAGRAM

E396783E06
0.25,1.969 1.823,2.521 1.573,0.552 10 false Air Conditioning Amplifier Assembly 5.531,1.948 6.927,2.594 1.396,0.646 10 false Seatback Heater Assembly LH 3.688,1.969 5.104,2.646 1.417,0.677 10 false Seat Cushion Heater Assembly LH 1.229,0.969 1.656,1.115 0.427,0.146 10 false TFAL 1.24,1.469 1.781,1.729 0.542,0.26 10 false SG-7 1.813,0.74 2.167,0.99 0.354,0.25 10 false 4 1.76,1.469 2.146,1.708 0.385,0.24 10 false I30 1.76,0.948 2.156,1.156 0.396,0.208 10 false I30 1.771,1.25 2.115,1.5 0.344,0.25 10 false 3 3.25,0.958 3.594,1.156 0.344,0.198 10 false k2 3.25,1.479 3.573,1.677 0.323,0.198 10 false k2 3.313,0.74 3.542,0.99 0.229,0.25 10 false 6 3.302,1.25 3.531,1.458 0.229,0.208 10 false 7 5.167,0.958 5.385,1.115 0.219,0.156 10 false A 5.167,1.479 5.385,1.635 0.219,0.156 10 false A 5.177,0.729 5.333,0.896 0.156,0.167 10 false 5 5.177,1.24 5.333,1.406 0.156,0.167 10 false 8

PROCEDURE

1.CLEAR DTC
a.

Clear the DTCs.

Body Electrical > Air Conditioner > Clear DTCs
50002 121

Result:
Proceed to
NEXT



NEXT

2.CHECK FOR DTC
2.CHECK FOR DTC
a.

Check for DTCs.

Body Electrical > Air Conditioner > Trouble Codes
50001 121

Result:
Result Proceed to
B14C3 is not output A
B14C3 is output B



A

B

3.CHECK HARNESS AND CONNECTOR (AIR CONDITIONING AMPLIFIER ASSEMBLY - SEATBACK HEATER ASSEMBLY LH)
3.CHECK HARNESS AND CONNECTOR (AIR CONDITIONING AMPLIFIER ASSEMBLY - SEATBACK HEATER ASSEMBLY LH)

Pre-procedure1

a.

Disconnect the D78 air conditioning amplifier assembly connector.


b.

Disconnect the M1 seatback heater assembly LH connector.


Procedure1

a.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition

Click Location & Routing(D78,M1)Location & Routing

Click Connector(D78)Instrument Panel>Instrument Panel Wire>Air Conditioning Amplifier Assembly

Click Connector(M1)Seat>No. 1 Rear Seat Wire / No. 2 Rear Seat Wire>Rear Seat Heater Assembly LH

D78-4 (TFAL) - M1-2 Always Below 1 Ω
D78-4 (TFAL) or M1-2 - Body ground Always 10 kΩ or higher
D78-19 (SG) - M1-3 Always Below 1 Ω
D78-19 (SG) or M1-3 - Body ground Always 10 kΩ or higher


Result:
Proceed to
OK
NG



Post-procedure1

a.

None



OK

4.INSPECT SEAT CUSHION HEATER ASSEMBLY LH

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR

4.INSPECT SEAT CUSHION HEATER ASSEMBLY LH

OK

5.CHECK SEATBACK HEATER ASSEMBLY LH

NG

REPLACE SEAT CUSHION HEATER ASSEMBLY LH

5.CHECK SEATBACK HEATER ASSEMBLY LH

Pre-procedure1

a.

Disconnect the M1 seatback heater assembly LH connector.


b.

Disconnect the seat cushion heater assembly LH connector.


Procedure1

a.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition

Click Location & Routing(M1)Location & Routing

Click Connector(M1)Seat>No. 1 Rear Seat Wire / No. 2 Rear Seat Wire>Rear Seat Heater Assembly LH

M1-2 - A-4 Always Below 1 Ω
M1-2 or A-4 - Body ground Always 10 kΩ or higher
M1-3 - A-5 Always Below 1 Ω
M1-3 or A-5 - Body ground Always 10 kΩ or higher


Result:
Proceed to
OK
NG



Post-procedure1

a.

None



OK

REPLACE AIR CONDITIONING AMPLIFIER ASSEMBLY

NG

REPLACE SEAT HEATER ASSEMBLY (REAR SEAT CUSHION LH)