Home › Engine / Hybrid System › HYBRID / BATTERY CONTROL › ACCELERATOR PEDAL SENSOR
RM37H0E _51 Engine / Hybrid System _096346 HYBRID / BATTERY CONTROL _0457188 ACCELERATOR PEDAL SENSOR A

HYBRID / BATTERY CONTROL  ACCELERATOR PEDAL SENSOR  INSTALLATION  


CAUTION / NOTICE / HINT

COMPONENTS (INSTALLATION)
A482692N01
5.792,0.813 6.771,1.01 0.979,0.198 5.75,0.76 6.823,1.063 1.073,0.302 6.01,2.719 6.99,2.917 0.979,0.198 5.958,2.667 7.031,2.969 1.073,0.302 5.135,0.76 5.406,0.323 5.406,0.323 5.583,0.323 false 5.865,1.885 6.177,1.458 6.177,1.458 6.365,1.458 false 4.823,2.094 5.031,2.094 false 5.625,1.25 5.625,0.917 5.625,0.917 5.792,0.917 false 6.292,1.813 6.458,1.813 6.458,1.813 6.458,2.708 false 6.156,1.938 6.615,2.135 0.458,0.198 10 false x 2 5.698,1.208 6.156,1.406 0.458,0.198 10 false x 3 6.469,1.313 6.75,1.667 0.281,0.354 18 false 1 5.854,0.208 6.135,0.563 0.281,0.354 18 false 3 4.604,1.979 4.885,2.333 0.281,0.354 18 false 2 5.854,0.854 6.875,1.125 1.021,0.271 8 false 7.5 (76, 66 in.*lbf) 6.063,2.76 7.083,3.031 1.021,0.271 8 false 7.5 (76, 66 in.*lbf)

Procedure Part Name Code
Z101186

Z101188

Z101187

1 ACCELERATOR PEDAL ASSEMBLY 78010F - - -
2 ACCELERATOR PEDAL PAD 78118 - - -
3 ACCELERATOR PEDAL(WITH SENSOR) ROD ASSEMBLY 78110K (Click here) - -

V111893

Tightening torque for "Major areas involving basic vehicle performance such as moving/turning/stopping": N*m (kgf*cm, ft.*lbf) - -

HINT:
·

Use the same procedure for RHD and LHD vehicles.

·

The procedure listed below is for LHD vehicles.



PROCEDURE

Hide 78010F 1.INSTALL ACCELERATOR PEDAL ASSEMBLY

Torque:
7.5 N*m (76 kgf*cm, 66 in.*lbf)

Hide 78118 2.INSTALL ACCELERATOR PEDAL PAD

Hide 78110K 3.INSTALL ACCELERATOR PEDAL(WITH SENSOR) ROD ASSEMBLY

Z101186

NOTICE:
·

Avoid excessive force to the accelerator pedal (with sensor) rod assembly.

·

Do not disassemble the accelerator pedal (with sensor) rod assembly assembly.

·

This accelerator pedal does not require lubrication.

Do not apply oil or lubricant to the accelerator pedal (with sensor) rod assembly assembly.

If applied, the accelerator pedal (with sensor) rod assembly assembly must be replaced.




Torque:
7.5 N*m (76 kgf*cm, 66 in.*lbf)