Home › Engine / Hybrid System › HYBRID / BATTERY CONTROL › HV BATTERY STACK
RM37H0E _51 Engine / Hybrid System _096346 HYBRID / BATTERY CONTROL _0457196 HV BATTERY STACK Y

HYBRID / BATTERY CONTROL  HV BATTERY STACK  BASIC INSPECTION  


DESCRIPTION

When replacing the No. 1 EV supply stack sub-assembly or No. 2 EV supply stack sub-assembly, it is necessary to check, adjust and equalize the SOC of the EV battery. Otherwise, resulting in a decrease in fuel efficiency.

PROCEDURE

1.READ VALUE USING GTS (EV Battery SOC)
a.

Read the Data List.

Powertrain > EV Battery > Data List
Tester Display
Hybrid/EV Battery SOC
50003 398 297

Result:
Result Proceed to
"Hybrid/EV Battery SOC" is 55 to 65% A
Other than above B


b.

Turn the ignition switch off.



A

3.REPLACE EV BATTERY (NO. 1 EV SUPPLY STACK SUB-ASSEMBLY or NO. 2 EV SUPPLY STACK SUB-ASSEMBLY)

B

2.ADJUST EV BATTERY SOC
2.ADJUST EV BATTERY SOC
HINT:

If the following procedure (charging or discharging of the EV battery) cannot be performed due to the condition of the vehicle, proceed to the next step.


a.

Apply the parking brake and chock all 4 wheels.


b.

Depress the accelerator pedal and brake pedal simultaneously or leave the vehicle with neutral (N) selected until the value of Data List item "Hybrid/EV Battery SOC" is between 55% and 65%.

Powertrain > EV Battery > Data List
Tester Display
Hybrid/EV Battery SOC
50003 398 297

HINT:
·

Depressing the accelerator pedal and brake pedal simultaneously will cause the EV battery to charge and the value of "Hybrid/EV Battery SOC" to increase.

·

Leaving the vehicle with neutral (N) selected will cause the EV battery to discharge and the value of "Hybrid/EV Battery SOC" to decrease.



c.

Turn the ignition switch off.


Result:
Proceed to
NEXT



NEXT

3.REPLACE EV BATTERY (NO. 1 EV SUPPLY STACK SUB-ASSEMBLY or NO. 2 EV SUPPLY STACK SUB-ASSEMBLY)
3.REPLACE EV BATTERY (NO. 1 EV SUPPLY STACK SUB-ASSEMBLY or NO. 2 EV SUPPLY STACK SUB-ASSEMBLY)

NEXT

4.ROAD TEST
4.ROAD TEST
a.

Turn the ignition switch on (READY).


b.

Drive the vehicle on urban roads for approximately 10 minutes.

HINT:

Perform this procedure in order to ensure the accuracy of the inspection in the next step.



c.

Turn the ignition switch off.


Result:
Proceed to
NEXT



NEXT

5.READ VALUE USING GTS (Delta SOC)
5.READ VALUE USING GTS (Delta SOC)
a.

Check and Record the Data List.

Powertrain > EV Battery > Data List
Tester Display
Delta SOC
50003 398 61
Result:
Result Proceed to
"Delta SOC" is 0 to 5% A
Other than above B



b.

Turn the ignition switch off.



A

END

B

6.TIME TO EQUALIZE SOC
6.TIME TO EQUALIZE SOC
a.

According to the value of Data List item "Delta SOC" recorded in the previous step, equalize the SOC.

"Delta SOC" Time to Equalize SOC
(Total time necessary to leave ignition switch off)
6 to 10% 29 hours
11 to 15% 49 hours
16 to 20% 66 hours
21 to 25% 85 hours
26 to 30% 103 hours


HINT:
·

SOC equalization is performed when the ignition switch is off.

·

It is not necessary to leave the ignition switch off continuously for the time shown in the table. The time shown is the cumulative time the ignition switch must be off after a EV supply stack sub-assembly has been replaced for SOC equalization to complete.



Result:
Proceed to
NEXT



NEXT

END