Home › Brake › BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS › ELECTRONICALLY CONTROLLED BRAKE SYSTEM
RM37H0E _54 Brake _096746 BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS _0459129 ELECTRONICALLY CONTROLLED BRAKE SYSTEM C

BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS  ELECTRONICALLY CONTROLLED BRAKE SYSTEM  C00631F  Yaw Rate Sensor Circuit Intermittent  C05201F  Multi-axis Acceleration Sensor Module "A" Circuit Intermittent  


DESCRIPTION

The airbag ECU assembly has a built-in yaw rate and acceleration sensor.

The No. 2 skid control ECU (brake actuator assembly) receives signals from the yaw rate and acceleration sensor (airbag ECU assembly) via CAN communication.

DTC No. Detection Item DTC Detection Condition Trouble Area DTC Output from Priority Note
C00631F Yaw Rate Sensor Circuit Intermittent When voltage at terminal +BS is 9.5 to 17.4 V, sensor invalid information received from yaw rate sensor is ON continuously for 10 seconds or more. Yaw rate sensor (airbag ECU assembly) Brake/EPB A Output ECU: No. 2 skid control ECU (brake actuator assembly)
C05201F Multi-axis Acceleration Sensor Module "A" Circuit Intermittent When voltage at terminal +BS is 9.5 to 17.4 V, sensor invalid information received from acceleration sensor is ON continuously for 10 seconds or more. Acceleration sensor (airbag ECU assembly) Brake/EPB A Output ECU: No. 2 skid control ECU (brake actuator assembly)

CAUTION / NOTICE / HINT

NOTICE:

After replacing or reinstalling the yaw rate and acceleration sensor (airbag ECU assembly), perform "Calibration".

Click hereBrake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>ELECTRONICALLY CONTROLLED BRAKE SYSTEM>UTILITY


PROCEDURE

1.CLEAR DTC

Pre-procedure1

a.

None


Procedure1

a.

Clear the DTCs.

Chassis > Brake/EPB > Clear DTCs
50002 435
Result:
Proceed to
NEXT



Post-procedure1

a.

Turn the ignition switch off.



NEXT

2.RECONFIRM DTC
2.RECONFIRM DTC

Pre-procedure1

a.

Based on the Freeze Frame Data and interview with the customer, attempt to reproduce the conditions when the malfunction occurred.


Procedure1

a.

Check if the same DTC is output.

Chassis > Brake/EPB > Trouble Codes
50001 435
Result:
Result Proceed to
C00631F and C05201F are not output A
C00631F or C05201F is output B



Post-procedure1

a.

None



A

B