Home › Brake › BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS › ELECTRONICALLY CONTROLLED BRAKE SYSTEM
RM37H0E _54 Brake _096746 BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS _0459129 ELECTRONICALLY CONTROLLED BRAKE SYSTEM C

BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS  ELECTRONICALLY CONTROLLED BRAKE SYSTEM  C006328  Yaw Rate Sensor Signal Bias Level Out of Range / Zero Adjustment Failure  C006396  Yaw Rate Sensor Component Internal Failure  


DESCRIPTION

The airbag ECU assembly has a built-in yaw rate and acceleration sensor.

These DTCs are stored when the No. 2 skid control ECU (brake actuator assembly) receives an internal malfunction signal from the yaw rate and acceleration sensor (airbag ECU assembly).

DTC No. Detection Item DTC Detection Condition Trouble Area DTC Output from Priority Note
C006328 Yaw Rate Sensor Signal Bias Level Out of Range / Zero Adjustment Failure With the vehicle stationary, the yaw rate sensor output value is not 0°/s. Yaw rate sensor (airbag ECU assembly) Brake/EPB A Output ECU: No. 2 skid control ECU (brake actuator assembly)
C006396 Yaw Rate Sensor Component Internal Failure With the +BS terminal voltage between 9.5 and 17.4 V, a data malfunction signal is received from a yaw rate sensor. Yaw rate sensor (airbag ECU assembly) Brake/EPB A Output ECU: No. 2 skid control ECU (brake actuator assembly)

CAUTION / NOTICE / HINT

NOTICE:

After replacing or reinstalling the yaw rate and acceleration sensor (airbag ECU assembly), perform "Calibration".

Click hereBrake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>ELECTRONICALLY CONTROLLED BRAKE SYSTEM>UTILITY


PROCEDURE

1.REPLACE AIRBAG ECU ASSEMBLY

NEXT

END