Home › Brake › BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS › ELECTRONICALLY CONTROLLED BRAKE SYSTEM
RM37H0E _54 Brake _096746 BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS _0459129 ELECTRONICALLY CONTROLLED BRAKE SYSTEM C

BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS  ELECTRONICALLY CONTROLLED BRAKE SYSTEM  C15057E  Brake Pressure Control solenoid "E" Actuator Stuck On  C150B7E  Brake Pressure Control solenoid "F" Actuator Stuck On  


DESCRIPTION

The No. 1 skid control ECU (brake booster with master cylinder assembly) controls braking force according to the hybrid control system regenerative braking force and provides the hydraulic pressure necessary for operating the master cylinder and each wheel cylinder according to the servo pressure sensor.

HINT:
·

Brake pressure control solenoid "E": Solenoid SSA

·

Brake pressure control solenoid "F": Solenoid SGH



DTC No. Detection Item DTC Detection Condition Trouble Area DTC Output from Priority Note
C15057E Brake Pressure Control solenoid "E" Actuator Stuck On When all of the following conditions are met, there is an SSA valve malfunction (stuck closed, etc.).
·

The vehicle was driven before the ignition switch was turned off.

·

90 seconds have elapsed since the ignition switch was turned off.

·

The vehicle is stopped and the shift position is P.


Brake booster with master cylinder assembly Brake Booster B Output ECU: No. 1 skid control ECU (brake booster with master cylinder assembly)
C150B7E Brake Pressure Control solenoid "F" Actuator Stuck On When all of the following conditions are met, there is a SGH valve malfunction (stuck closed, etc.).
·

The vehicle was driven before the ignition switch was turned off.

·

90 seconds have elapsed since the ignition switch was turned off.

·

The vehicle is stopped and the shift position is P.


Brake booster with master cylinder assembly Brake Booster B Output ECU: No. 1 skid control ECU (brake booster with master cylinder assembly)

CAUTION / NOTICE / HINT

NOTICE:

After replacing the No. 1 skid control ECU (brake booster with master cylinder assembly), perform "Calibration".

Click hereBrake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>ELECTRONICALLY CONTROLLED BRAKE SYSTEM>UTILITY


PROCEDURE

1.CHECK DTC
a.

Check the DTCs that are output.

Chassis > Brake Booster > Trouble Codes
50001 466

Result:
Result Proceed to
Only C15057E or C150B7E is output A
C15057E or C150B7E and other DTCs are output B



A

2.CHECK DTC

B

REPAIR CIRCUITS INDICATED BY OUTPUT DTCS

2.CHECK DTC
a.

Check the DTCs that are output.

Chassis > Brake/EPB > Trouble Codes
50001 435

Result:
Result Proceed to
DTCs are not output A
DTCs are output B



A

REPLACE BRAKE BOOSTER WITH MASTER CYLINDER ASSEMBLY

B

REPAIR CIRCUITS INDICATED BY OUTPUT DTCS