Home › Brake › BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS › ELECTRONICALLY CONTROLLED BRAKE SYSTEM
RM37H0E _54 Brake _096746 BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS _0459129 ELECTRONICALLY CONTROLLED BRAKE SYSTEM J

BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS  ELECTRONICALLY CONTROLLED BRAKE SYSTEM  ACC Low Pressure (X21A9)  


DESCRIPTION

Code Tester Display Measurement Item Trouble Area Output ECU
X21A9 ACC Low Pressure History of a continuous and significant decrease in accumulator pressure
·

Accumulator pressure dropped due to frequent brake pedal operation

·

Pump motor malfunction

·

Accumulator deterioration

·

Accumulator pressure sensor (brake booster with master cylinder assembly)

·

Supply voltage reduced


No. 1 skid control ECU (brake booster with master cylinder assembly)

PROCEDURE

1.CHECK DTC (HEALTH CHECK)
a.

Perform the Health Check using the GTS.


Result:
Result Proceed to
DTCs are not output. A
DTCs are output. B



A

2.CLEAR VEHICLE CONTROL HISTORY (RoB)

B

GO TO DIAGNOSTIC TROUBLE CODE CHART

2.CLEAR VEHICLE CONTROL HISTORY (RoB)
a.

Using the GTS, clear the Vehicle Control History (RoB).

Chassis > Brake Booster > Utility
Tester Display
Vehicle Control History (RoB)
50005 466 1055

Result:
Proceed to
NEXT



NEXT

3.CHECK VEHICLE CONTROL HISTORY (RoB)
3.CHECK VEHICLE CONTROL HISTORY (RoB)
a.

Based on the Freeze Frame Data and interview with the customer, attempt to reproduce the conditions when the malfunction occurred.


b.

Using the GTS, check for Vehicle Control History (RoB).

Chassis > Brake Booster > Utility
Tester Display
Vehicle Control History (RoB)
50005 466 1055

Result:
Result Proceed to
X21A9 is not output. A
X21A9 is output. B



A

END

B

GO TO BRAKE SYSTEM ON-VEHICLE INSPECTION