The rear side ultrasonic sensor (RLS sensor) is installed on the rear bumper. The clearance warning ECU assembly detects obstacles based on signals it receives from the rear side ultrasonic sensor (RLS sensor). If an open circuit or other malfunction occurs in the rear side ultrasonic sensor (RLS sensor), the rear side ultrasonic sensor (RLS sensor) does not operate correctly.
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area | DTC Output from | Priority |
|---|---|---|---|---|---|
| C1AF196 | Ultrasonic Sensor (Rear Left Side) Component Internal Failure | Rear side ultrasonic sensor (RLS sensor) malfunction | ·
Rear side ultrasonic sensor (RLS sensor) ·
Clearance warning ECU assembly |
Clearance Warning | B |
Perform registration after replacing or removing and installing the ultrasonic sensor or clearance warning ECU assembly.
Click hereAudio / Visual / Telematics>PARK ASSIST / MONITORING>TOYOTA PARKING ASSIST-SENSOR SYSTEM>CALIBRATION
If a DTC is detected again after the repair, turn the ignition switch to ON and turn the TOYOTA parking assist-sensor system on, and then clear the DTC.
Check for DTCs.
| Result | Proceed to |
|---|---|
| C1AF196 is not output | A |
| C1AF196 is output | B |
| C1AF187 and C1AF196 are output | C |
A
Click hereGeneral>INTRODUCTION>HOW TO TROUBLESHOOT ECU CONTROLLED SYSTEMS>HOW TO PROCEED WITH TROUBLESHOOTING
B
C
Click hereAudio / Visual / Telematics>PARK ASSIST / MONITORING>TOYOTA PARKING ASSIST-SENSOR SYSTEM>C1AF187
Replace the rear side ultrasonic sensor (RLS sensor) with a known good one.
Click hereAudio / Visual / Telematics>PARK ASSIST / MONITORING>ULTRASONIC SENSOR (for Rear)>REMOVAL
All of the sensors are interchangeable. To confirm whether a sensor is functioning normally, switch it with a known good sensor from the other end of the vehicle.
| Proceed to |
|---|
| NEXT |
NEXT
Clear the DTCs.
| Proceed to |
|---|
| NEXT |
NEXT
Check for DTCs.
| Result | Proceed to |
|---|---|
| C1AF196 is not output | A |
| C1AF196 is output | B |
A
B