Home › Audio / Visual / Telematics › PARK ASSIST / MONITORING › PANORAMIC VIEW MONITOR SYSTEM
RM37H0E _56 Audio / Visual / Telematics _095293 PARK ASSIST / MONITORING _0455115 PANORAMIC VIEW MONITOR SYSTEM C

PARK ASSIST / MONITORING  PANORAMIC VIEW MONITOR SYSTEM  C1611  ECU Malfunction  


DESCRIPTION

This DTC is stored if the rear television camera assembly judges that there is an internal malfunction as a result of its self check.

HINT:

The rear television camera assembly stores different types of information during initialization. If the rear television camera assembly cannot read the stored information when it is activated, the rear television camera assembly judges that there is an internal malfunction and stores this DTC.


DTC No. Detection Item DTC Detection Condition Trouble Area DTC Output from Priority
C1611 ECU Malfunction When any of the following conditions is met:
·

EEPROM status (Initial read) malfunction

·

CPU communication malfunction

·

Video output malfunction


Rear television camera assembly Rear Camera A

CAUTION / NOTICE / HINT

NOTICE:
·

When "!" mark is displayed on the multi-display assembly after the cable is disconnected from the negative (-) auxiliary battery terminal, correct the steering angle neutral point.

Click hereAudio / Visual / Telematics>PARK ASSIST / MONITORING>PANORAMIC VIEW MONITOR SYSTEM>INITIALIZATION

·

Depending on the parts that are replaced or operations that are performed during vehicle inspection or maintenance, calibration of other systems as well as the panoramic view monitor system may be needed.

Click hereAudio / Visual / Telematics>PARK ASSIST / MONITORING>PANORAMIC VIEW MONITOR SYSTEM>CALIBRATION



PROCEDURE

1.READ VALUE USING GTS
a.

Read the Data List according to the display on the GTS.

Chassis > Rear Camera > Data List
Tester Display Measurement Item Range Normal Condition Diagnostic Note
Video Output Status Output condition of video signal OK or NG OK: Output condition of video signal is normal
NG: Output condition of video signal is abnormal
-
EEPROM Status (Initial read) Rear television camera assembly information OK or NG OK: Rear television camera assembly normal
NG: Rear television camera assembly abnormal
-
CPU Communication Status Rear television camera assembly information OK or NG OK: Rear television camera assembly normal
NG: Rear television camera assembly abnormal
-
Chassis > Rear Camera > Data List
Tester Display
Video Output Status
EEPROM Status (Initial read)
CPU Communication Status
50003 85 69,36,43
Result:
Result Proceed to
OK is displayed for all items A
NG is displayed for EEPROM status (Initial read)
NG is displayed for items other than EEPROM status (Initial read) B




A

2.PERFORM CALIBRATION

B

2.PERFORM CALIBRATION
a.

Perform the following procedure depending on the memory conditions to register the vehicle information into the rear television camera assembly.

i.

Rear television camera assembly optical axis adjustment (back camera position setting).

Click hereAudio / Visual / Telematics>PARK ASSIST / MONITORING>PANORAMIC VIEW MONITOR SYSTEM>CALIBRATION




Result:
Proceed to
NEXT



NEXT

3.CLEAR DTC
3.CLEAR DTC
a.

Clear the DTCs.

Chassis > Rear Camera > Clear DTCs
50002 85

Result:
Proceed to
NEXT



NEXT

4.CHECK FOR DTC
4.CHECK FOR DTC
a.

Recheck for DTCs and check that no DTCs are output.

Chassis > Rear Camera > Trouble Codes
50001 85
HINT:
·

If DTC C1611 is output, perform the procedure to allow the rear television camera assembly to store the vehicle information again.

·

If DTC C1611 is still output after performing the procedure to make the rear television camera assembly store the vehicle information 3 times, replace the rear television camera assembly.




Result:
Result Proceed to
C1611 is not output A
C1611 is output B



A

END

B