Home › Audio / Visual / Telematics › PARK ASSIST / MONITORING › PANORAMIC VIEW MONITOR SYSTEM
RM37H0E _56 Audio / Visual / Telematics _095293 PARK ASSIST / MONITORING _0455115 PANORAMIC VIEW MONITOR SYSTEM C

PARK ASSIST / MONITORING  PANORAMIC VIEW MONITOR SYSTEM  C168D  Vehicle Information Unmatched  


DESCRIPTION

This DTC is stored if the rear television camera assembly judges as a result of its self check that the vehicle information received via CAN communication and the vehicle information stored in the television camera controller do not match.

DTC No. Detection Item DTC Detection Condition Trouble Area DTC Output from Priority
C168D Vehicle Information Unmatched Vehicle information unmatched
·

Camera view adjustment (calibration)

·

Steering angle setting

·

Rear Television Camera Assembly


Rear Camera A

CAUTION / NOTICE / HINT

NOTICE:
·

When "!" mark is displayed on the multi-display assembly after the cable is disconnected from the negative (-) auxiliary battery terminal, correct the steering angle neutral point.

Click hereAudio / Visual / Telematics>PARK ASSIST / MONITORING>PANORAMIC VIEW MONITOR SYSTEM>INITIALIZATION

·

Depending on the parts that are replaced or operations that are performed during vehicle inspection or maintenance, calibration of other systems as well as the panoramic view monitor system may be needed.

Click hereAudio / Visual / Telematics>PARK ASSIST / MONITORING>PANORAMIC VIEW MONITOR SYSTEM>CALIBRATION



PROCEDURE

1.CHECK FOR DTC
a.

Check for DTCs.

Chassis > Rear Camera > Trouble Codes
50001 85

Result:
Result Proceed to
C168D is not output A
C168D is output B



A

B

2.PERFORM SETTINGS (BACK CAMERA POSITION SETTING, STEERING ANGLE SETTING)
2.PERFORM SETTINGS (BACK CAMERA POSITION SETTING, STEERING ANGLE SETTING)
a.

Perform the following procedure depending on the memory conditions to register the vehicle information into the rear television camera assembly.

i.

Refer to rear television camera assembly optical axis adjustment (back camera position setting).

Click hereAudio / Visual / Telematics>PARK ASSIST / MONITORING>PANORAMIC VIEW MONITOR SYSTEM>CALIBRATION




Result:
Proceed to
NEXT



NEXT

3.CHECK FOR DTC
3.CHECK FOR DTC
a.

Recheck for DTCs and check that no DTCs are output.

Chassis > Rear Camera > Trouble Codes
50001 85
HINT:
·

If DTC C168D is output, perform the procedure to register the vehicle information into the rear television camera assembly.

·

If DTC C168D is still output after performing the procedure to register the vehicle information into the rear television camera assembly 3 times, replace the rear television camera assembly.




Result:
Result Proceed to
C168D is not output A
C168D is output B



A

END

B