This DTC is stored when the parking assist ECU judges that the maximum steering angle has not been memorized (steering angle setting is incomplete).
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area | DTC Output from | Priority |
|---|---|---|---|---|---|
| C1694 | Steering Angle Initialization Incomplete | Maximum steering angle has not been memorized | ·
Steering angle setting ·
Rear Television Camera Assembly |
Rear Camera | A |
When "!" mark is displayed on the multi-display assembly after disconnecting the cable from the negative (-) auxiliary battery terminal, correct the steering angle neutral point.
Click hereAudio / Visual / Telematics>PARK ASSIST / MONITORING>PANORAMIC VIEW MONITOR SYSTEM>INITIALIZATION
Depending on the parts that are replaced or operations that are performed during vehicle inspection or maintenance, calibration of other systems as well as the panoramic view monitor system may be needed.
Click hereAudio / Visual / Telematics>PARK ASSIST / MONITORING>PANORAMIC VIEW MONITOR SYSTEM>CALIBRATION
Perform the following procedure depending on the memory conditions to register the vehicle information to the parking assist ECU.
Refer to steering angle setting.
Click hereAudio / Visual / Telematics>PARK ASSIST / MONITORING>PANORAMIC VIEW MONITOR SYSTEM>CALIBRATION
| Proceed to |
|---|
| NEXT |
NEXT
Check for DTCs.
If DTC C1694 is output, perform the steering angle setting again.
If DTC C1694 is still output after performing the steering angle setting 3 times, replace the parking assist ECU.
| Result | Proceed to |
|---|---|
| C1694 is not output | A |
| C1694 is output | B |
A
B