This DTC is stored when the rear television camera assembly receives an invalid communication signal from the blind spot monitor sensor RH.
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area | DTC Output from | Priority |
|---|---|---|---|---|---|
| C2A5C | BSM Buzzer Sound Request Signal Malfunction | An invalid communication signal is received from the blind spot monitor sensor RH | Rear television camera assembly | Rear Camera | A |
When "!" is displayed on the multi-display assembly after the cable is disconnected from the negative (-) auxiliary battery terminal, correct the steering angle neutral point.
Click hereAudio / Visual / Telematics>PARK ASSIST / MONITORING>PANORAMIC VIEW MONITOR SYSTEM>INITIALIZATION
Depending on the parts that are replaced or operations that are performed during vehicle inspection or maintenance, calibration of other systems as well as the panoramic view monitor system may be needed.
Click hereAudio / Visual / Telematics>PARK ASSIST / MONITORING>PANORAMIC VIEW MONITOR SYSTEM>CALIBRATION
Clear the DTCs.
| Proceed to |
|---|
| NEXT |
NEXT
Recheck for DTCs and check that no DTCs are output.
| Result | Proceed to |
|---|---|
| C2A5C is not output | A |
| C2A5C is output | B |
A
Click hereGeneral>INTRODUCTION>HOW TO TROUBLESHOOT ECU CONTROLLED SYSTEMS>HOW TO PROCEED WITH TROUBLESHOOTING
B