Home › Engine / Hybrid System › HYBRID / BATTERY CONTROL › HYBRID CONTROL SYSTEM
RM37H0E _51 Engine / Hybrid System _096346 HYBRID / BATTERY CONTROL _0463852 HYBRID CONTROL SYSTEM C

HYBRID / BATTERY CONTROL  HYBRID CONTROL SYSTEM  U042481  HVAC Control Module to Hybrid Powertrain Control Module Invalid Serial Data Received  


DESCRIPTION

If the EV control ECU receives an invalid compressor control request from the air conditioning amplifier assembly via CAN communication, it will store this DTC.

DTC No. Detection Item DTC Detection Condition Trouble Area Warning Indicate DTC Output from Priority
U042481 HVAC Control Module to Hybrid Powertrain Control Module Invalid Serial Data Received Invalid control request received from the air conditioning amplifier assembly
(1 trip detection logic)
Air conditioning amplifier assembly Master Warning:
Does not come on
EV B

CONFIRMATION DRIVING PATTERN

HINT:

After repairs have been completed, clear the DTCs and then check that the vehicle has returned to normal by performing the following All Readiness check procedure.

Click hereEngine / Hybrid System>HYBRID / BATTERY CONTROL>HYBRID CONTROL SYSTEM>UTILITY


1.

Clear the DTCs (even if no DTCs are stored, perform the clear DTC procedure).

2.

Turn the ignition switch off and wait for 10 minutes or more.

3.

Wait for 1 minute or more with the vehicle stopped, the ignition switch ON (READY), park (P) selected and the air conditioning system on (Lo/COOL MAX, blower speed HI).

4.

Turn the air conditioning system off and wait for 10 seconds or more with the ignition switch ON (READY).

5.

Enter the following menus: Powertrain / EV / Utility / All Readiness.

6.

Check the DTC judgment result.

HINT:
·

If the judgment result shows NORMAL, the system is normal.

·

If the judgment result shows ABNORMAL, the system has a malfunction.

·

If the judgment result shows INCOMPLETE, perform driving pattern again.




CAUTION / NOTICE / HINT

NOTICE:
·

This vehicle performs FC system shutdown process after turning the ignition switch off from ON (READY). Therefore, after the ignition switch is turned off from ON (READY), do not perform any work on the electrical system for at least 10 minutes including removing connectors or disconnecting the negative (-) auxiliary battery terminal.

·

When the EV control ECU determines that the temperature of FC system components is below 0°C (32°F) when the vehicle is parked with the ignition switch off, it operates the FC air compressor, hydrogen pump and FC cooling water pump for a maximum of 180 seconds to drain the FC stack assembly. When performing inspection or repairs with the ignition switch off (not ON or ON (READY)), disconnect the cable from the negative (-) auxiliary battery terminal before performing work. (If the auxiliary battery voltage is needed to conduct inspection, perform the inspection in an environment with an ambient temperature of 10°C (50°F) or higher.)



PROCEDURE

1.CHECK DTC OUTPUT (AIR CONDITIONER)

Pre-procedure1

a.

None.


Procedure1

a.

Check if DTCs related to the air conditioning system (A/C) are output.

Body Electrical > Air Conditioner > Trouble Codes
50001 121
Result:
Result Proceed to
DTCs are not output A
DTCs are output B



Post-procedure1

a.

Turn the ignition switch off.



A

REPLACE AIR CONDITIONING AMPLIFIER ASSEMBLY

B