|
N*m (kgf*cm, ft.*lbf): Specified torque | - | - |
898A8
1.INSTALL NO. 2 FC CONTROL ECU BRACKET
898A7
2.INSTALL NO. 1 FC CONTROL ECU BRACKET
898A1
3.INSTALL FC CONTROL ECU
Install the FC control ECU with the 2 nuts.
If the FC control ECU is dropped or subjected to a strong impact, replace it with a new one.
Connect the 2 FC control ECU connectors and lock with the lever.
When connecting connectors, make sure that foreign substances such as mud or water droplets do not adhere to them.
Securely lock with the lever.
53292A
4.INSTALL UPPER RADIATOR SUPPORT SEAL
5.CONNECT CABLE TO NEGATIVE AUXILIARY BATTERY TERMINAL
6. INITIALIZATION AFTER RECONNECTING BATTERY TERMINAL
Click hereGeneral>SETUP>WHEN DISCONNECTING OR RECONNECTING BATTERY TERMINAL>WORK PROCEDURE
When disconnecting and reconnecting the battery, there is an automatic learning function that completes learning when the respective system is used.
Click hereGeneral>SETUP>WHEN DISCONNECTING OR RECONNECTING BATTERY TERMINAL>AUTOMATIC LEARNING CHART