| Procedure | Part Name Code |
|
|
|
|
|---|---|---|---|---|---|
| 1 | ROCKER PANEL MOULDING PROTECTOR LH | 75866E | - | - | - |
| 2 | ROCKER PANEL MOULDING ASSEMBLY LH | - | ( )
|
- | - |
Use the same procedure for the RH and LH sides.
The procedure described below is for the LH side.
75866E
1.REMOVE ROCKER PANEL MOULDING PROTECTOR LH
|
Screw<A> |
|
Screw<B> |
|
Clip | - | - |
2.REMOVE ROCKER PANEL MOULDING ASSEMBLY LH
|
Screw |
|
Clip<A> |
|
Clip<B> | - | - |
Put protective tape around the rocker panel moulding assembly LH.
Remove the 7 screws.
Remove the 5 clips<A>.
Using needle-nose pliers, detach the 7 clips<B>.
Detach the clip and remove the rocker panel moulding assembly LH.