| Procedure | Part Name Code |
|
|
|
|
|---|---|---|---|---|---|
| 1 | FRONT DOOR UPPER WINDOW FRAME MOULDING LH | 75754A | - | - | - |
| 2 | FRONT DOOR FRONT LOWER FRAME UPPER COVER LH | 67496C | - | - | - |
The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed, installed or replaced during the front door front lower frame upper cover removal/installation are shown below.
When the cable is disconnected/reconnected to the auxiliary battery terminal, systems temporarily stop operating. However, each system has a function that completes learning the first time the system is used.
Learning completes when vehicle is driven
Learning completes when vehicle is operated normally
| Effect/Inoperative Function When Necessary Procedures are not Performed | Necessary Procedures | Link |
|---|---|---|
| Air conditioning system | After the ignition switch is turned to ON, the servo motor and expansion valve standard position is recognized. | - |
Use the same procedure for the RH and LH sides.
The procedure described below is for the LH side.
75754A
1.REMOVE FRONT DOOR UPPER WINDOW FRAME MOULDING LH
67496C
2.REMOVE FRONT DOOR FRONT LOWER FRAME UPPER COVER LH