Home › Engine / Hybrid System › FC CONTROL › FC CONTROL SYSTEM
RM37H0E _51 Engine / Hybrid System _095966 FC CONTROL _0466766 FC CONTROL SYSTEM C

FC CONTROL  FC CONTROL SYSTEM  P222A12  Barometric Pressure Sensor "B" Circuit Short to Battery  P222A14  Barometric Pressure Sensor "B" Circuit Short to Ground or Open  


DESCRIPTION

The EV control ECU regulates in accordance with the operating environment by monitoring atmospheric pressures via the barometric pressure sensor provided on the circuit board of the EV control ECU.

DTC No. Detection Item DTC Detection Condition Trouble Area Warning Indicate DTC Output from Priority
P222A12 Barometric Pressure Sensor "B" Circuit Short to Battery Barometric Pressure Sensor Voltage remains at more than 4.7 V for more than 3 seconds (short to +B in the atmospheric pressure sensor).
(1 trip detection logic)
EV control ECU (barometric pressure sensor) Master Warning: Comes on EV A
P222A14 Barometric Pressure Sensor "B" Circuit Short to Ground or Open Barometric Pressure Sensor Voltage remains at less than 0.3 V for more than 3 seconds (open or short to ground in the atmospheric pressure sensor).
(1 trip detection logic)
EV control ECU (barometric pressure sensor) Master Warning: Comes on EV A

Related Data List
DTC No. Data List
P222A12
·

Atmospheric Pressure Sensor Voltage

·

Atmospheric Pressure (Filtered Value)


P222A14

CAUTION / NOTICE / HINT

NOTICE:
·

This vehicle performs FC system shutdown process after turning the ignition switch off from ON (READY). Therefore, after the ignition switch is turned off from ON (READY), do not perform any work on the electrical system for at least 10 minutes including removing connectors or disconnecting the negative (-) auxiliary battery terminal.

·

When the EV control ECU determines that the temperature of FC system components is below 0°C (32°F) when the vehicle is parked with the ignition switch off, it operates the FC air compressor, hydrogen pump and FC cooling water pump for a maximum of 180 seconds to drain the FC stack assembly. When performing inspection or repairs with the ignition switch off (not ON or ON (READY)), disconnect the cable from the negative (-) auxiliary battery terminal before performing work. (If the auxiliary battery voltage is needed to conduct inspection, perform the inspection in an environment with an ambient temperature of 10°C (50°F) or higher.)



HINT:

After the repair, clear the DTCs and perform the following procedure to check that DTCs are not output.

1.

Turn the ignition switch to ON and wait for 3 seconds or more.



PROCEDURE

1.REPLACE EV CONTROL ECU (BAROMETER PRESSURE SENSOR)

NEXT

END