Home › Engine / Hybrid System › FC CONTROL › FC CONTROL SYSTEM
RM37H0E _51 Engine / Hybrid System _095966 FC CONTROL _0466766 FC CONTROL SYSTEM Y

FC CONTROL  FC CONTROL SYSTEM  HOW TO PROCEED WITH TROUBLESHOOTING  


CAUTION / NOTICE / HINT

HINT:
·

*: Use the GTS

·

Use the following procedure to troubleshoot the FC control system.



PROCEDURE

1.VEHICLE BROUGHT TO WORKSHOP
Result:
Proceed to
NEXT



NEXT

2.CUSTOMER PROBLEM ANALYSIS
2.CUSTOMER PROBLEM ANALYSIS
Result:
Proceed to
NEXT



NEXT

3.CONNECT GTS TO THE DLC3*
3.CONNECT GTS TO THE DLC3*
HINT:

If the display on the GTS indicates a communication error, inspect the DLC3.


Result:
Proceed to
NEXT



NEXT

4.CHECK DTC AND FREEZE FRAME DATA*
4.CHECK DTC AND FREEZE FRAME DATA*
HINT:
·

Make sure to save freeze frame data because the data is necessary for performing simulation tests.

·

For the FC control system, there are many DTCs, many of which can be stored due to a single malfunction. As a result, in some of the diagnosis procedures an instruction is provided to check for other DTCs and their corresponding INF codes. By following the diagnosis path based on the combination of output DTCs and INF codes, it is possible to narrow down the problem early and avoid unnecessary diagnosis.



Result:
Proceed to
NEXT



NEXT

5.CLEAR DTC AND FREEZE FRAME DATA*
5.CLEAR DTC AND FREEZE FRAME DATA*
Result:
Proceed to
NEXT



NEXT

6.CONDUCT VISUAL INSPECTION
6.CONDUCT VISUAL INSPECTION
Result:
Proceed to
NEXT



NEXT

7.CONFIRM PROBLEM SYMPTOMS
7.CONFIRM PROBLEM SYMPTOMS
Result:
Proceed to
Malfunction does not occur.
Malfunction occurs.



Malfunction does not occur.

8.DUPLICATE CONDITIONS THAT PRODUCE SYMPTOMS

Malfunction occurs.

10.REFER TO DTC CHART
8.DUPLICATE CONDITIONS THAT PRODUCE SYMPTOMS
Result:
Proceed to
NEXT



NEXT

9.CHECK FOR DTCS*
9.CHECK FOR DTCS*
Result:
Proceed to
DTCs are output.
DTCs are not output.



DTCs are output.

10.REFER TO DTC CHART

DTCs are not output.

16.CONDUCT BASIC INSPECTION
10.REFER TO DTC CHART

NEXT

11.CONDUCT CIRCUIT INSPECTION
11.CONDUCT CIRCUIT INSPECTION
Result:
Proceed to
Malfunction not confirmed.
Malfunction confirmed.



Malfunction not confirmed.

12.CHECK FOR INTERMITTENT PROBLEMS

Malfunction confirmed.

13.IDENTIFY PROBLEM
12.CHECK FOR INTERMITTENT PROBLEMS

NEXT

13.IDENTIFY PROBLEM
13.IDENTIFY PROBLEM
Result:
Proceed to
NEXT



NEXT

14.ADJUST AND/OR REPAIR
14.ADJUST AND/OR REPAIR
Result:
Proceed to
NEXT



NEXT

15.CONDUCT CONFIRMATION TEST
15.CONDUCT CONFIRMATION TEST
Result:
Proceed to
NEXT



NEXT

END

16.CONDUCT BASIC INSPECTION
Result:
Proceed to
Malfunctioning parts not confirmed.
Malfunctioning parts confirmed.



Malfunctioning parts not confirmed.

17.CHECK ECU POWER SOURCE CIRCUIT

Malfunctioning parts confirmed.

18.CONDUCT PARTS INSPECTION
17.CHECK ECU POWER SOURCE CIRCUIT
Result:
Proceed to
NEXT



NEXT

11.CONDUCT CIRCUIT INSPECTION
18.CONDUCT PARTS INSPECTION
Result:
Proceed to
NEXT



NEXT

13.IDENTIFY PROBLEM