Home › Vehicle Interior › HEATING / AIR CONDITIONING › AIR CONDITIONING SYSTEM
RM37H0E _58 Vehicle Interior _095300 HEATING / AIR CONDITIONING _0455055 AIR CONDITIONING SYSTEM C

HEATING / AIR CONDITIONING  AIR CONDITIONING SYSTEM  B14C7  Electric Water Pump Circuit  


DESCRIPTION

The air conditioning amplifier assembly uses the target blower temperature to calculate the target water temperature, and performs control of the heater water pump with motor assembly based on the water temperature sensor value.

DTC No. Detection Item DTC Detection Condition Trouble Area Memory DTC Output from Priority
B14C7 Electric Water Pump Circuit
Diagnosis condition:

When water with motor pump assembly is driven


Malfunction status:

Even if water with motor pump assembly drive signal is output, but water with motor pump assembly speed is 500 rpm or less


Detection time:

Detects malfunction signal for 10 seconds or more


·

Water with motor pump assembly

·

Harness or connector

·

Air conditioning amplifier assembly


Memorized
(10 seconds or more)
Air Conditioner A

HINT:

The air conditioning amplifier assembly stores this DTC if the malfunction has occurred for the period of time indicated in the parentheses.


WIRING DIAGRAM

E457275E01
4.656,2.813 6.906,3.135 2.25,0.323 10 false Air Conditioning Amplifier Assembly 2.188,2.792 2.5,2.99 0.313,0.198 10 false B4 2.188,2.948 4.385,3.208 2.198,0.26 10 false Water with Motor Pump Assembly 4.5,0.875 4.813,1.073 0.313,0.198 10 false D78 4.5,2.271 4.813,2.469 0.313,0.198 10 false D80 4.521,0.635 4.833,0.833 0.313,0.198 10 false 17 4.938,0.74 5.25,0.938 0.313,0.198 10 false WP 4.979,2.146 5.292,2.344 0.313,0.198 10 false WIP 4.51,2.021 4.823,2.219 0.313,0.198 10 false 12 5.896,1.76 6.208,1.958 0.313,0.198 10 false 5 V 4.063,0.75 4.375,0.948 0.313,0.198 10 false 3 4.083,2.146 4.396,2.344 0.313,0.198 10 false 2 3.625,0.75 3.938,0.948 0.313,0.198 10 false SWP 3.615,2.146 3.927,2.344 0.313,0.198 10 false NWP 2.656,0.74 2.969,0.938 0.313,0.198 10 false +B 2.677,2.146 2.99,2.344 0.313,0.198 10 false VV- 2.365,0.74 2.677,0.938 0.313,0.198 10 false 4 2.375,2.146 2.688,2.344 0.313,0.198 10 false 1 0.49,0.833 2.052,1.073 1.563,0.24 10 false from Auxiliary Battery

CAUTION / NOTICE / HINT

NOTICE:

DTC B14C7 may be output when the self-protection function of the water with motor pump assembly activates and stops the pump due to foreign matter jamming the pump or air in the coolant passages causing the pump to run dry.


PROCEDURE

1.PERFORM ACTIVE TEST USING GTS (WATER PUMP)
a.

Check the operation by referring to the table below.

Body Electrical > Air Conditioner > Active Test
Tester Display Measurement Item Control Range Diagnostic Note
Water Pump Water with motor pump assembly OFF, ON -
Body Electrical > Air Conditioner > Active Test
Tester Display
Water Pump
50004 121 20
OK:

Water with motor pump assembly controls on and off using the GTS operation.



Result:
Proceed to
OK
NG



OK

REPLACE AIR CONDITIONING AMPLIFIER ASSEMBLY

NG

2.CHECK HARNESS AND CONNECTOR (WATER WITH MOTOR PUMP ASSEMBLY - BODY GROUND)
2.CHECK HARNESS AND CONNECTOR (WATER WITH MOTOR PUMP ASSEMBLY - BODY GROUND)

Pre-procedure1

a.

Disconnect the B4 water with motor pump assembly connector.


Procedure1

a.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition

Click Location & Routing(B4)Location & Routing

Click Connector(B4)Engine Compartment>No. 2 Stack Wire>Water Pump with Motor Assembly

B4-1 (VV-) - Body ground Always Below 1 Ω



Result:
Proceed to
OK
NG


Post-procedure1

a.

None



OK

3.CHECK HARNESS AND CONNECTOR (WATER WITH MOTOR PUMP ASSEMBLY - BATTERY)

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR

3.CHECK HARNESS AND CONNECTOR (WATER WITH MOTOR PUMP ASSEMBLY - BATTERY)

Pre-procedure1

a.

Disconnect the B4 water with motor pump assembly connector.


Procedure1

a.

Measure the voltage according to the value(s) in the table below.

Standard Voltage:
Tester Connection Switch Condition Specified Condition

Click Location & Routing(B4)Location & Routing

Click Connector(B4)Engine Compartment>No. 2 Stack Wire>Water Pump with Motor Assembly

B4-4 (+B) - Body ground Ignition switch ON 11 to 14 V



Result:
Proceed to
OK
NG


Post-procedure1

a.

None



OK

4.CHECK HARNESS AND CONNECTOR (WATER WITH MOTOR PUMP ASSEMBLY - AIR CONDITIONING AMPLIFIER ASSEMBLY)

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR

4.CHECK HARNESS AND CONNECTOR (WATER WITH MOTOR PUMP ASSEMBLY - AIR CONDITIONING AMPLIFIER ASSEMBLY)

Pre-procedure1

a.

Disconnect the B4 water with motor pump assembly connector.


b.

Disconnect the D78 and D80 air conditioning amplifier assembly connectors.


Procedure1

a.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition

Click Location & Routing(B4,D78,D80)Location & Routing

Click Connector(B4)Engine Compartment>No. 2 Stack Wire>Water Pump with Motor Assembly

Click Connector(D78)Instrument Panel>Instrument Panel Wire>Air Conditioning Amplifier Assembly

Click Connector(D80)Instrument Panel>Instrument Panel Wire>Air Conditioning Amplifier Assembly

B4-3 (SWP) - D78-17 (WP) Always Below 1 Ω
B4-2 (NWP) - D80-12 (WIP) Always Below 1 Ω
B4-3 (SWP) or D78-17 (WP) - Other terminals and body ground Always 10 kΩ or higher
B4-2 (NWP) or D80-12 (WIP) - Other terminals and body ground Always 10 kΩ or higher



Result:
Proceed to
OK
NG


Post-procedure1

a.

None



OK

5.REPLACE WATER WITH MOTOR PUMP ASSEMBLY

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR

5.REPLACE WATER WITH MOTOR PUMP ASSEMBLY
a.

Replace the water with motor pump assembly with a new or known good one.

HINT:

Click hereVehicle Interior>HEATING / AIR CONDITIONING>HEATER WATER PUMP>REMOVAL



Result:
Proceed to
NEXT



NEXT

6.CLEAR DTC
6.CLEAR DTC
a.

Clear the DTCs.

Body Electrical > Air Conditioner > Clear DTCs
50002 121

Result:
Proceed to
NEXT



NEXT

7.CHECK FOR DTC
7.CHECK FOR DTC
a.

Check for DTCs.

Body Electrical > Air Conditioner > Trouble Codes
50001 121

Result:
Result Proceed to
B14C7 is not output A
B14C7 is output B



A

END (WATER WITH MOTOR PUMP ASSEMBLY WAS DEFECTIVE)

B

REPLACE AIR CONDITIONING AMPLIFIER ASSEMBLY