| *1 | LOWER NO. 3 STEERING WHEEL COVER | *2 | LOWER NO. 2 STEERING WHEEL COVER |
Use the same procedure for RHD and LHD vehicles.
The procedure listed below is for LHD vehicles.
45130
1.INSTALL HORN BUTTON ASSEMBLY
| *a | Turns off | - | - |
Check that the ignition switch is off.
Check that the cable is disconnected from the negative (-) auxiliary battery terminal.
Wait at least 60 seconds after disconnecting the cable from the negative (-) auxiliary battery terminal to disable the SRS system.
If the airbag deploys for any reason, it may cause a serious accident.
| *A | for Dual Type | - | - |
Attach the wire harness clamp.
Connect the horn connector.
for Single Type:
Connect the airbag connector.
When connecting any airbag connector, take care not to damage the airbag wire harness.
Be sure to connect the connectors to each corresponding color.
Make sure the lock button is securely locked.
Refer to How to Connect or Disconnect Airbag Connector: Click hereVehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM>HOW TO CONNECT OR DISCONNECT AIRBAG CONNECTOR
for Dual Type:
Connect the 2 airbag connectors.
When connecting any airbag connector, take care not to damage the airbag wire harness.
Be sure to connect the connectors to each corresponding color.
Make sure the lock button is securely locked.
Refer to How to Connect or Disconnect Airbag Connector: Click hereVehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM>HOW TO CONNECT OR DISCONNECT AIRBAG CONNECTOR
Set the horn button assembly to the steering wheel assembly.
Check that the airbag wire harness and horn wire harness are not pinched.
Press the horn button assembly with both hands to attach the upper pin to the upper spring.
Press the horn button assembly with both hands to attach the lower pin to the lower spring.
After installation, try to pull the horn button assembly and check that the horn button assembly is securely installed.
Attach the guide and claw to install the lower No. 2 steering wheel cover.
Attach the guide and claw to install the lower No. 3 steering wheel cover.
2.CONNECT CABLE TO NEGATIVE AUXILIARY BATTERY TERMINAL
3. INITIALIZATION AFTER RECONNECTING BATTERY TERMINAL
Click hereGeneral>SETUP>WHEN DISCONNECTING OR RECONNECTING BATTERY TERMINAL>WORK PROCEDURE
When disconnecting and reconnecting the battery, there is an automatic learning function that completes learning when the respective system is used.
Click hereGeneral>SETUP>WHEN DISCONNECTING OR RECONNECTING BATTERY TERMINAL>AUTOMATIC LEARNING CHART
4.CHECK SRS WARNING LIGHT
45130
5.INSPECT HORN BUTTON ASSEMBLY
6. PERFORM DIAGNOSTIC SYSTEM CHECK