| *A | w/ Navigation System | *B | w/o Navigation System |
|
Tightening torque for "Major areas involving basic vehicle performance such as moving/turning/stopping": N*m (kgf*cm, ft.*lbf) | - | - |
Use the same procedure for RHD and LHD vehicles.
The procedure listed below is for LHD vehicles.
73960A
1.INSTALL INSTRUMENT PANEL PASSENGER WITHOUT DOOR AIRBAG ASSEMBLY
55403E
2.INSTALL NO. 2 INSTRUMENT PANEL SAFETY PAD SUB-ASSEMBLY
|
Install in this Direction | - | - |
Attach the clip and install the No. 2 instrument panel safety pad sub-assembly as shown in the illustration.
Install the 4 bolts.
| *A | for Dual Type | - | - |
Install the 2 bolts.
for Single Type:
Connect the airbag connector.
Refer to How to Connect or Disconnect Airbag Connector:
for Dual Type:
Connect the 2 airbag connectors.
Refer to How to Connect or Disconnect Airbag Connector:
Attach the clamp.
55550
3.INSTALL GLOVE COMPARTMENT DOOR ASSEMBLY
4.INSTALL MULTI-DISPLAY ASSEMBLY WITH BRACKET (w/ Navigation System)
5.INSTALL RADIO AND DISPLAY RECEIVER ASSEMBLY WITH BRACKET (w/o Navigation System)
6.CONNECT CABLE TO NEGATIVE AUXILIARY BATTERY TERMINAL
7.CHECK SRS WARNING LIGHT
8. INITIALIZATION AFTER RECONNECTING BATTERY TERMINAL
Click hereGeneral>SETUP>WHEN DISCONNECTING OR RECONNECTING BATTERY TERMINAL>WORK PROCEDURE
When disconnecting and reconnecting the battery, there is an automatic learning function that completes learning when the respective system is used.
Click hereGeneral>SETUP>WHEN DISCONNECTING OR RECONNECTING BATTERY TERMINAL>AUTOMATIC LEARNING CHART
9. PERFORM DIAGNOSTIC SYSTEM CHECK