Depending on the parts that are replaced during vehicle inspection or maintenance, performing initialization, registration or calibration may be needed. Refer to Precaution for Telematics System (for TOYOTA Connect).
Click hereAudio / Visual / Telematics>TELEMATICS>TELEMATICS SYSTEM (for TOYOTA Connect)>PRECAUTION
When replacing the telematics transceiver, make sure to replace it with a new one.
Disconnect the D62 radio receiver assembly connector.
Disconnect the D68 telematics transceiver connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
|
Click Location & Routing(D62,D68)Location & Routingewd_type=routing;type=c,c;code=D62,D68 Click Connector(D62)Instrument Panel>Instrument Panel Wire>Radio Receiver Assemblyewd_type=component;type=c;code=D62;pinno=13,14,15,16 Click Connector(D68)Instrument Panel>Instrument Panel Wire>Telematics Transceiverewd_type=component;type=c;code=D68;pinno=17,33,18,34 |
||
| D62-13 (VOR+) - D68-17 (VOT+) | Always | Below 1 Ω |
| D62-14 (VOR-) - D68-33 (VOT-) | Always | Below 1 Ω |
| D62-15 (VOT+) - D68-18 (VOR+) | Always | Below 1 Ω |
| D62-16 (VOT-) - D68-34 (VOR-) | Always | Below 1 Ω |
| D62-13 (VOR+) - Body ground | Always | 10 kΩ or higher |
| D62-14 (VOR-) - Body ground | Always | 10 kΩ or higher |
| D62-15 (VOT+) - Body ground | Always | 10 kΩ or higher |
| D62-16 (VOT-) - Body ground | Always | 10 kΩ or higher |
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Remove the radio receiver assembly with the connectors still connected.
Click hereAudio / Visual / Telematics>AUDIO / VIDEO>RADIO RECEIVER>REMOVAL
| *a | Component with harness connected
(Radio Receiver Assembly) |
Check for pulses according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
|
Click Location & Routing(D62)Location & Routingewd_type=routing;type=c;code=D62 Click Connector(D62)Instrument Panel>Instrument Panel Wire>Radio Receiver Assemblyewd_type=component;type=c;code=D62;pinno=15,16 |
||
| D62-15 (VOT+) - Body ground | Calling while using the operator service | A waveform synchronized with the sent voice is output |
| D62-16 (VOT-) - Body ground | Calling while using the operator service | A waveform synchronized with the sent voice is output |
| Proceed to |
|---|
| OK |
| NG |
OK
NG