| *1 | HOOD LOCK CONTROL LEVER | - | - |
|
Tightening torque for "Major areas involving basic vehicle performance such as moving/turning/stopping": N*m (kgf*cm, ft.*lbf) | - | - |
Use the same procedure for RHD and LHD vehicles.
The procedure listed below is for LHD vehicles.
73900
1.INSTALL LOWER NO. 1 INSTRUMENT PANEL AIRBAG ASSEMBLY
| *a | Turns off | - | - |
Check that the ignition switch is off.
Check that the cable is disconnected from the negative (-) auxiliary battery terminal.
Wait at least 60 seconds after disconnecting the cable from the negative (-) auxiliary battery terminal to disable the SRS system.
If the airbag deploys for any reason, it may cause a serious accident.
|
Install in this Direction | - | - |
Connect the airbag connector.
Refer to How to Connect or Disconnect Airbag Connector:
Attach the wire harness clamp.
Insert the hood lock control lever until the hood lock control lever locks.
Attach the hook to install the lower No. 1 instrument panel airbag assembly.
Install the 4 bolts.
55046A
2.INSTALL LOWER INSTRUMENT PANEL FINISH PANEL SUB-ASSEMBLY LH
58833B
3.INSTALL UPPER NO. 1 CONSOLE PANEL GARNISH
55045
4.INSTALL LOWER INSTRUMENT PANEL FINISH PANEL SUB-ASSEMBLY
55471A
5.INSTALL INSTRUMENT CLUSTER FINISH PANEL ORNAMENT
55317E
6.INSTALL NO. 1 INSTRUMENT SIDE PANEL
55606
7.INSTALL NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY
67914B
8.INSTALL FRONT DOOR SCUFF PLATE LH
9.CONNECT CABLE TO NEGATIVE AUXILIARY BATTERY TERMINAL
10.CHECK SRS WARNING LIGHT
11. INITIALIZATION AFTER RECONNECTING BATTERY TERMINAL
Click hereGeneral>SETUP>WHEN DISCONNECTING OR RECONNECTING BATTERY TERMINAL>WORK PROCEDURE
When disconnecting and reconnecting the battery, there is an automatic learning function that completes learning when the respective system is used.
Click hereGeneral>SETUP>WHEN DISCONNECTING OR RECONNECTING BATTERY TERMINAL>AUTOMATIC LEARNING CHART
12. PERFORM DIAGNOSTIC SYSTEM CHECK