|
Tightening torque for "Major areas involving basic vehicle performance such as moving/turning/stopping": N*m (kgf*cm, ft.*lbf) | - | - |
73990
1.INSTALL LOWER NO. 2 INSTRUMENT PANEL AIRBAG ASSEMBLY
| *a | Turns off | - | - |
Check that the ignition switch is off.
Check that the cable is disconnected from the negative (-) auxiliary battery terminal.
Wait at least 60 seconds after disconnecting the cable from the negative (-) auxiliary battery terminal to disable the SRS system.
If the airbag deploys for any reason, it may cause a serious accident.
|
Install in this Direction | - | - |
Connect the airbag connector.
When connecting any airbag connector, take care not to damage the airbag wire harness.
Make sure the lock button is securely locked.
Refer to How to Connect or Disconnect Airbag Connector.
Attach the clip to install the lower No. 2 instrument panel airbag assembly.
Install the 2 bolts.
58834B
2.INSTALL UPPER NO. 2 CONSOLE PANEL GARNISH
55318F
3.INSTALL NO. 2 INSTRUMENT SIDE PANEL
55607
4.INSTALL NO. 2 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY
67913
5.INSTALL FRONT DOOR SCUFF PLATE RH
6.CONNECT CABLE TO NEGATIVE AUXILIARY BATTERY TERMINAL
7. INITIALIZATION AFTER RECONNECTING AUXILIARY BATTERY TERMINAL
Click hereGeneral>SETUP>WHEN DISCONNECTING OR RECONNECTING BATTERY TERMINAL>WORK PROCEDURE
When disconnecting and reconnecting the auxiliary battery, there is an automatic learning function that completes learning when the respective system is used.
Click hereGeneral>SETUP>WHEN DISCONNECTING OR RECONNECTING BATTERY TERMINAL>AUTOMATIC LEARNING CHART
8. PERFORM DIAGNOSTIC SYSTEM CHECK
9.CHECK SRS WARNING LIGHT