Home › Vehicle Interior › SUPPLEMENTAL RESTRAINT SYSTEMS › AIRBAG SYSTEM › from 2021.08
RM37H0E _58 Vehicle Interior _095287 SUPPLEMENTAL RESTRAINT SYSTEMS _0455058 AIRBAG SYSTEM C

SUPPLEMENTAL RESTRAINT SYSTEMS  AIRBAG SYSTEM  B179312  Load Sensor for Occupant Detection System Circuit Short to Battery  B179316  Load Sensor for Occupant Detection System Circuit Voltage Below Threshold  B179317  Load Sensor for Occupant Detection System Circuit Voltage Above Threshold  


DESCRIPTION

DTC No. Detection Item DTC Detection Condition Trouble Area Warning Indicate DTC Output from Priority Test Mode / Check Mode
B179312 Load Sensor for Occupant Detection System Circuit Short to Battery An occupant detection ECU malfunction. Airbag ECU assembly Comes on SRS Airbag B Not applicable
B179316 Load Sensor for Occupant Detection System Circuit Voltage Below Threshold An occupant detection ECU malfunction. Airbag ECU assembly Comes on SRS Airbag B Not applicable
B179317 Load Sensor for Occupant Detection System Circuit Voltage Above Threshold An occupant detection ECU malfunction. Airbag ECU assembly Comes on SRS Airbag B Not applicable

CAUTION / NOTICE / HINT

NOTICE:
·

After the ignition switch is turned off, there may be a waiting time before disconnecting the negative (-) auxiliary battery terminal.

Click hereGeneral>SETUP>WHEN DISCONNECTING OR RECONNECTING BATTERY TERMINAL>BEFORE DISCONNECTING BATTERY

·

When disconnecting and reconnecting the auxiliary battery

Click hereGeneral>SETUP>WHEN DISCONNECTING OR RECONNECTING BATTERY TERMINAL>WORK PROCEDURE

HINT:

When disconnecting and reconnecting the auxiliary battery, there is an automatic learning function that completes learning when the respective system is used.

Click hereGeneral>SETUP>WHEN DISCONNECTING OR RECONNECTING BATTERY TERMINAL>AUTOMATIC LEARNING CHART


·

After replacing the airbag ECU assembly, refer to initialization.

Click hereGeneral>SETUP>WHEN REPLACING OR REMOVING/INSTALLING PARTS>WORK PROCEDURE



PROCEDURE

1.CHECK DTC

Pre-procedure1

a.

Turn the ignition switch to ON, and wait for at least 60 seconds.


Procedure1

a.

Check for DTCs.

Body Electrical > SRS Airbag > Trouble Codes
50001 444

Result:
Result Proceed to
B179312, B179316 or B179317 is output A
B179312, B179316, B179317 and other DTCs are output B


NOTICE:

If only DTC B179312, B179316 or B179317is output, do not clear the DTCs. Replace the airbag ECU assembly.


HINT:

If any DTCs other than B179312, B179316 or B179317 are also output, troubleshoot those DTCs first.


Post-procedure1

a.

None



A

B