CHECK MULTIPLEX NETWORK DOOR ECU
Disconnect the G15 multiplex network door ECU connector.
Measure the voltage and resistance according to the value(s) in the table below.
| Terminal No. (Symbol) | Terminal Description | Condition | Specified Condition |
|---|---|---|---|
| G15-1 (GND) - Body ground | Ground | Always | Below 1 Ω |
| G15-16 (IG) - Body ground | IG power supply | Ignition switch ON | 11 to 14 V |
| Ignition switch off | Below 1 V | ||
| G15-18 (ECUB) - Body ground | Battery power supply | Ignition switch off | 11 to 14 V |
| G15-19 (B) - Body ground | Battery power supply | Ignition switch off | 11 to 14 V |
Reconnect the G15 multiplex network door ECU connector.
Measure the voltage and resistance according to the value(s) in the table below.
| Terminal No. (Symbol) | Terminal Description | Condition | Specified Condition |
|---|---|---|---|
| G15-4 (CSV) - Body ground | Luggage door closer assembly (door sensor) power supply | Always | 7 V or higher |
| G15-5 (CS1) - Body ground | Luggage door closer assembly (door sensor 1) signal | Luggage compartment door closer operating | Pulse generation
(See waveform 2) |
| G15-6 (LCM+) - Body ground | Luggage door closer assembly (closer motor) output signal | Luggage compartment door closer motor is operated | 11 to 14 V |
| Luggage compartment door closer motor is not operated | Below 1 V | ||
| G15-7 (LCM-) - Body ground | Luggage door closer assembly (closer motor) output signal | Luggage compartment door closer motor is operated in reverse | 11 to 14 V |
| Luggage compartment door closer motor is not operated | Below 1 V | ||
| G15-8 (SWG) - Body ground | Luggage door closer assembly (half latch switch and pawl switch) ground | Always | Below 1 Ω |
| G15-9 (CSG) - Body ground | Luggage door closer assembly (door sensor) ground | Always | Below 1 Ω |
| G15-13 (HAF) - Body ground | Luggage door closer assembly (half latch switch) input signal | Luggage closer motor assembly detecting a luggage compartment door ajar | Pulse generation |
| Luggage closer motor assembly not detecting a luggage compartment door ajar | Below 1 V | ||
| G15-14 (PAWL) - Body ground | Luggage door closer assembly (pawl switch) input signal | Luggage closer motor assembly detecting a luggage compartment door ajar | Below 1 V |
| Luggage closer motor assembly not detecting a luggage compartment door ajar | Pulse generation | ||
| G15-17 (CS2) - Body ground | Luggage door closer assembly (door sensor 2) signal | Luggage compartment door closer operating | Pulse generation
(See waveform 2) |
Using an oscilloscope, check waveform 1.
| Item | Condition |
|---|---|
| Tester Connection | G15-17 (CS2) - Body ground |
| Tool Setting | 2V/DIV, 10 ms/DIV. |
| Vehicle Condition | Luggage compartment door closer operating |
The period changes in accordance with the speed at which the luggage compartment door is opened and closed.
Using an oscilloscope, check waveform 2.
| Item | Condition |
|---|---|
| Tester Connection | G15-5 (CS1) - Body ground |
| Tool Setting | 2V/DIV, 10 ms/DIV. |
| Vehicle Condition | Luggage compartment door closer operating |
The period changes in accordance with the speed at which the luggage compartment door is opened and closed.
CHECK CERTIFICATION ECU (SMART KEY ECU ASSEMBLY)