The headlight ECU sub-assembly sends control signals to the headlight leveling motor via LIN communication.
The headlight leveling motor operates according to the power supply and control signals from the headlight ECU sub-assembly and sends its operation status to the headlight ECU sub-assembly via LIN communication.
When there is a malfunction in the LIN communication, B2424 or B2425 is output.
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area | DTC Output from | Priority | Note |
|---|---|---|---|---|---|---|
| B2417 | Headlight Beam Level Control Motor LH Malfunction | Detection condition:
Ignition switch ON Malfunction status:
Malfunction in headlight leveling motor LH Malfunction duration:
- |
Headlight leveling motor LH | AFS | A | - |
| B2418 | Headlight Beam Level Control Motor RH Malfunction | Detection condition:
Ignition switch ON Malfunction status:
Malfunction in headlight leveling motor RH Malfunction duration:
- |
Headlight leveling motor RH | AFS | A | - |
Pre-procedure1
None
Procedure1
Clear the DTCs.
| Proceed to |
|---|
| NEXT |
Post-procedure1
None
NEXT
Pre-procedure1
Turn the ignition switch ON and wait for at least 10 seconds or more.
Procedure1
Check for DTCs.
| Proceed to | |
|---|---|
| B2417 or B2418 is not output | A |
| B2417 is output | B |
| B2418 is output | C |
Post-procedure1
None
A
Click hereGeneral>INTRODUCTION>HOW TO TROUBLESHOOT ECU CONTROLLED SYSTEMS>HOW TO PROCEED WITH TROUBLESHOOTING
B
C