FRONT SEAT SIDE AIRBAG ASSEMBLY > DISPOSAL |
| 1. DISPOSE OF FRONT SEAT SIDE AIRBAG ASSEMBLY TOGETHER WITH VEHICLE |
![]() |
Check if SST is functioning properly .
Follow the "Precaution" (Click here).
Disconnect the cable from the negative (-) battery terminal. Wait at least 90 seconds after disconnecting the cable to prevent the airbag from deploying.
Remove the front seat (Click here).
Install SST.
Disconnect the yellow connector from the front seat side airbag.
![]() |
Connect the SST connector to the front seat side airbag connector.
Install the front seat (Click here).
![]() |
Move SST at least 10 m (33 ft.) away from the vehicle front side window.
Maintaining enough clearance for the SST wire harness in the front side window, close all the doors and windows of the vehicle.
Connect the SST's red clip to the battery positive (+) terminal and the black clip to the battery negative (-) terminal.
Deploy the airbag.
Check that no one is inside the vehicle or within a 10 m (33 ft.) radius of the vehicle.
Press the SST activation switch and deploy the airbag.
| 2. DISPOSE OF ONLY FRONT SEAT SIDE AIRBAG ASSEMBLY |
![]() |
Check if SST is functioning properly .
Remove the front seat side airbag.
Remove the front seat (Click here).
Remove the 2 nuts and the front seat side airbag from the seatback assembly.
![]() |
Using a service wire harness for the vehicle, tie down the front seat side airbag to the tire.
![]() |
Install the 2 nuts to the front seat side airbag.
![]() |
Wind the wire harness around the stud bolts of the front seat side airbag as shown in the illustration.
![]() |
Position the front seat side airbag inside the tire.
Install SST.
![]() |
Connect the SST connector to the front seat side airbag connector.
![]() |
Place the tires.
Place at least 2 tires under the tire to which the front seat side airbag is tied.
Place at least 2 tires over the tire to which the front seat side airbag is tied. The top tire should have a disc wheel installed.
![]() |
Tie the tires together with 2 wire harnesses.
Install SST.
![]() |
Connect the SST connector.
Deploy the airbag.
Connect the SST's red clip to the battery positive (+) terminal and the black clip to the battery negative (-) terminal.
Check that no one is within a 10 m (33 ft.) radius of the airbag.
Press the SST activation switch and deploy the airbag.
![]() |
Dispose of the front seat side airbag assembly.
Remove the front seat side airbag from the tire.
Place the front seat side airbag in a plastic bag, tie it tightly and dispose of it in the same way as other general parts.