CURTAIN SHIELD AIRBAG ASSEMBLY > DISPOSAL |
| 1. DISPOSE OF CURTAIN SHIELD AIRBAG ASSEMBLY TOGETHER WITH VEHICLE |
![]() |
Check if SST is functioning properly .
Follow the "Precaution" (Click here).
Disconnect the cable from the negative battery terminal. Wait at least 90 seconds after disconnecting the cable to prevent the airbag from deploying.
Remove the roof headlining assembly (Click here).
Install SST.
Disconnect the connector from the curtain shield airbag.
![]() |
After connecting SST to each other, connect them to the curtain shield airbag.
![]() |
Move SST at least 10 m (33 ft.) away from the vehicle rear side window.
Maintaining enough clearance for the SST wire harness in the rear side window, close all the doors and windows of the vehicle.
Connect the SST's red clip to the battery positive (+) terminal and the black clip to the battery negative (-) terminal.
Deploy the airbag.
Check that no one is inside the vehicle or within a 10 m (33 ft.) radius of the vehicle.
Press the SST activation switch and deploy the airbag.
| 2. DISPOSE OF ONLY CURTAIN SHIELD AIRBAG ASSEMBLY |
![]() |
Check if SST is functioning properly .
Remove the curtain shield airbag assembly (Click here).
![]() |
Cut off the deployment section of the curtain shield airbag.
![]() |
Using a service wire harness for the vehicle, tie down the curtain shield airbag to the tire.
![]() |
Position the curtain shield airbag inside the tire as shown in the illustration.
Install SST.
![]() |
After connecting SST to each other, connect them to the curtain shield airbag.
Place the tires.
![]() |
Place at least 2 tires under the tire to which the curtain shield airbag is tied.
Place at least 2 tires over the tire to which the curtain shield airbag is tied. The top tire should have a disc wheel installed.
![]() |
Tie the tires together with 2 wire harnesses.
Install SST.
![]() |
Connect the SST connector.
Deploy the airbag.
Connect the SST's red clip to the battery positive (+) terminal and the black clip to the battery negative (-) terminal.
Check that no one is within a 10 m (33 ft.) radius of the airbag.
Press the SST activation switch and deploy the airbag.
![]() |
Dispose of the curtain shield airbag.
Remove the curtain shield airbag from the tire.
Place the curtain shield airbag in a plastic bag, tie it tightly and dispose of it in the same way as other general parts.