Home › ENGINE › 1NZ-FXE ENGINE CONTROL SYSTEM › SFI SYSTEM

DTC    P0604    Internal Control Module Random Access Memory (RAM) Error

for Preparation Click here


DESCRIPTION

The ECM continuously monitors its internal memory status. This self-check ensures that the ECM is functioning properly. It is diagnosed by internal "mirroring" of the main CPU and sub CPU to detect the Random Access Memory (RAM) errors. If outputs from these CPUs are different and deviate from the standards, the ECM will illuminate the MIL and set a DTC immediately.

DTC
DTC Detection Condition
Trouble Area
P0604
ECM RAM errors
(1-trip detection logic)
ECM

MONITOR STRATEGY


Related DTC
P0604: ECM RAM error
Required sensors/Components
ECM
Frequency of Operation
Continuous
Duration
16 seconds
MIL Operation
Immediate
Sequence of Operation
None

TYPICAL ENABLING CONDITIONS


Monitor will run whenever this DTC is not present
None

TYPICAL MALFUNCTION THRESHOLDS


Main CPU and sub CPU mirroring
Fail

INSPECTION PROCEDURE

1.CHECK WHETHER DTC OUTPUT RECURS (DTC P0604)
  1. Connect Techstream to the DLC3.

  1. Turn the power switch ON (IG) and turn the tester on.

  1. Clear the DTCs (Click here).

  1. Turn the power switch OFF and turn the tester off.

  1. Disconnect the battery negative terminal and wait for 1 minute.

  1. Connect the battery negative terminal.

  1. Turn the power switch ON (IG) and turn the tester on.

  1. Select the following menu items: Powertrain / Engine and ECT / Trouble Code.

  1. Read the DTCs.

    Result:
    Display (DTC output)
    Proceed to
    P0604
    A
    No output
    B



B
CHECK FOR INTERMITTENT PROBLEMS
A

REPLACE ECM