TIRE PRESSURE WARNING SYSTEM > SYSTEM DESCRIPTION |
| DESCRIPTION OF SYSTEM |
Each tire pressure warning valve and transmitter is equipped with a tire pressure sensor and a transmitter and is installed in each tire wheel assembly. The sensor measures the tire pressure. The measured value and transmitter ID are transmitted to the tire pressure warning antenna and receiver on the body as radio waves and then sent to the tire pressure warning ECU from the tire pressure warning antenna and receiver. If the transmitter ID has already been registered, the ECU compares the measured air pressure value with the standard value. When the value is less than the standard value registered in the tire pressure warning ECU, the warning light on the combination meter illuminates.
When it is necessary to change the tire pressure setting, use the tire pressure warning reset switch to initialize the system.

| INITIAL CHECK |
![]() |
After the power switch is turned on (IG), the tire pressure warning light turns on for 3 seconds and then turns off.
| Trouble Area | Proceed to |
| Tire pressure warning light circuit |
Click here
|
| WHEN TIRE PRESSURE WARNING LIGHT IS LIT |
If the tire pressure warning light does not go off, or if it turns on while driving, check the tire pressure. If the tire pressure warning light turns on within several hours of adjusting the tire pressure, the tire may have a slow air leak.
Under the following conditions, the system may not function properly:
The system will be disabled in the following conditions:
(When the condition becomes normal, the system will work properly.)
The system may be disabled in the following conditions:
(When the condition becomes normal, the system will work properly.)
The average usage life of the grommets of the tire pressure warning valve and transmitter is approximately 10 years, at which time it must be replaced. If a tire pressure warning valve and transmitter is removed from a wheel, replace the grommet with a new one.
After removing and installing the ECU or a sensor, check for a diagnostic trouble code and verify that it is a normal code.
| FUNCTION OF COMPONENTS |
| Components | Function |
| Tire pressure warning valve and transmitter | Combined as a single unit with a disc wheel air valve, it measures tire pressure and temperature and transmits an ID number for measurement values and identification. Has a built-in battery. |
| Tire pressure warning antenna and receiver | Receives signals from a transmitter and sends the signals to the tire pressure warning ECU. |
| Tire pressure warning ECU | Receives the signal from the receiver and identifies it as the vehicle's own signal. If the measured value is equal to or lower than the specified value, it transmits a signal so that the tire pressure warning light on the combination meter turns on. |
| Tire pressure warning light | Located in the combination meter, it informs the driver of lowered tire pressure or system failure. |
| Tire pressure warning reset switch | Enters the initialization mode for tire or wheel replacement. |
| TIRE PRESSURE WARNING RESET SWITCH |