Home › SUSPENSION & AXLE › TIRE AND WHEEL › TIRE PRESSURE WARNING SYSTEM

TIRE PRESSURE WARNING SYSTEM > Tire Pressure Warning Light Circuit

for Preparation Click here


DESCRIPTION

When the tire pressure decreases, the ECU sends the communication signal to the combination meter assembly through the BEAN, and it illuminates the tire pressure warning light on the combination meter assembly.
The tire pressure warning light also turns on when the signal for the tire pressure warning light is cut off.

HINT:
Refer to the "TIRE PRESSURE WARNING LIGHT CHART" section of the "DIAGNOSIS SYSTEM" for checking the condition of the tire pressure warning light (Click here).


WIRING DIAGRAM


C128027E01


INSPECTION PROCEDURE

NOTICE:
  1. When replacing the tire pressure warning ECU, read the IDs stored in the old ECU using the Techstream and write them down before removal.
  2. It is necessary to perform initialization (Click here) after registration (Click here) of the transmitter IDs into the tire pressure warning ECU, after the ECU has been replaced.

1.CHECK DTC (MULTIPLEX COMMUNICATION SYSTEM)
  1. Check if DTC B1247 is output in the multiplex communication system (Click here).

    Result:
    Result
    Proceed to
    DTC B1247 is not output
    A
    DTC B1247 is output
    B



B
GO TO MULTIPLEX COMMUNICATION SYSTEM (Click here)
A


2.CHECK OPERATION OF TIRE PRESSURE WARNING LIGHT (ACTIVE TEST)
  1. Turn the power switch off.

  1. Connect the Techstream to the DLC3.

  1. Turn the power switch on (IG) and turn the Techstream on.

  1. Enter the following menus: Body / Combination Meter / Active Test.

  1. Check the condition of the tire pressure warning light by operating Techstream.

    Combination Meter 
    Tester Display
    Test Part
    Control Range
    Diagnostic Note
    Indicat. Lamp Tire Pressure
    Tire Pressure Warning Light
    Tire pressure warning light is ON / OFF
    Confirm that the vehicle is stopped with the engine idling

    OK:
    The warning light turns on when operating Techstream.



NG
GO TO METER / GAUGE SYSTEM (Click here)
OK

REPLACE TIRE PRESSURE WARNING ECU (Click here)