TIRE PRESSURE WARNING SYSTEM > HOW TO PROCEED WITH TROUBLESHOOTING |
| 1.VEHICLE BROUGHT TO WORKSHOP |
| |||||
| 2.CUSTOMER PROBLEM ANALYSIS |
Interview the customer to confirm the trouble.
| |||||
| 3.ADJUST TIRE PRESSURE* |
Turn the power switch off.
Connect the Techstream to the DLC3.
Turn the power switch on (IG) and the Techstream on.
Enter the following menus:
Select: Chassis / Tire Pressure / Data List.
Read the "ID Tire Inflation Pressure" values.
Adjust all tire pressures to the standard values (Click here).
Check the DATA LIST (Click here).
| Result | Proceed to |
| Tire pressure warning light goes off. | A |
| Tire pressure warning light remains on. | B |
|
| ||||
| |||||
| 4.CHECK FOR DTC (MULTIPLEX COMMUNICATION SYSTEM)* |
Check for DTC.
| Result | Proceed to |
| Multiplex communication system DTC is not output | A |
| Multiplex communication system DTC is output | B |
|
| ||||
| |||||
| 5.CHECK FOR DTC* |
Check for DTC (Click here).
| Result | Proceed to |
| DTC is not output | A |
| DTC is output | B |
|
| ||||
| |||||
| 6.DTC CHART |
Refer to the DIAGNOSTIC TROUBLE CODE CHART (Click here).
|
| ||||
|---|---|---|---|---|---|
| 7.PROBLEM SYMPTOMS TABLE |
Refer to the PROBLEM SYMPTOMS TABLE (Click here).
| |||||
| 8.CIRCUIT INSPECTION* |
Refer to the ELECTRONIC CIRCUIT INSPECTION PROCEDURE (Click here).
| |||||
| 9.REPAIR OR REPLACE |
Repair or replace parts based on the diagnosis result.
| |||||
| 10.CONFIRMATION TEST* |
Check the DATA LIST to confirm that the tire inflation pressure has been received (Click here).
Perform initialization (Click here).
Confirm that the initialization has been completed.
|
| ||||
|---|---|---|---|---|---|