Home › SUSPENSION & AXLE › TIRE AND WHEEL › TIRE PRESSURE WARNING SYSTEM

TIRE PRESSURE WARNING SYSTEM > DIAGNOSIS SYSTEM

for Preparation Click here



CHECK BATTERY VOLTAGE
If the voltage is below 11 V, recharge the battery before proceeding to the next step.

Standard voltage:
11 to 14 V


CHECK DLC3


    H100769E66
  1. The ECU uses ISO 15765-4 for communication protocol. The terminal arrangement of the DLC3 complies with SAE J1962 and matches the ISO 15765-4 format.

    Symbols (Terminal NO. )
    Terminal Description
    Condition
    Specified Condition
    SIL (7) - SG (5)
    Bus "+" line
    During transmission
    Pulse generation
    CG (4) - Body ground
    Chassis ground
    Always
    Below 1 Ω
    SG (5) - Body ground
    Signal ground
    Always
    Below 1 Ω
    BAT (16) - Body ground
    Battery positive
    Always
    11 to 14 V
    CANH (6) - CANL (14)
    CAN bus line
    Power switch off*
    54 to 69 Ω
    CANH (6) - CG (4)
    HIGH-level CAN bus line
    Power switch off*
    200 Ω or higher
    CANL (14) - CG (4)
    LOW-level CAN bus line
    Power switch off*
    200 Ω or higher
    CANH (6) - BAT (16)
    HIGH-level CAN bus line
    Power switch off*
    6 kΩ or higher
    CANL (14) - BAT (16)
    LOW-level CAN bus line
    Power switch off*
    6 kΩ or higher

    NOTICE:
    *Before measuring the resistance, leave the vehicle as is for at least 1 minute and do not operate the power switch, or any other switches or the doors.

  2. If the result is not as specified, DLC3 may have a malfunction. Repair or replace the harness and connector.

    HINT:
    Connect the Techstream cable to DLC3, turn the power switch on (IG) and attempt to use the Techstream. If the display indicates that a communication error has occurred, there is a problem either with the vehicle or with the Techstream.
    1. If communication is normal when the Techstream is connected to another vehicle, inspect DLC3 of the original vehicle.
    2. If communication is still not possible when the Techstream is connected to another vehicle, the problem may be in the Techstream itself. Consult the Service Department listed in the Techstream instruction manual.


DIAGNOSIS SYSTEM


    F100812E01
  1. Warning light

    1. When there is a problem with the tire pressure warning system, the tire pressure warning light blinks at 0.5 second intervals.

      NOTICE:
      When the malfunction has been corrected, the tire pressure warning light does not turn on.

  2. DTCs (Normal mode)

    1. DTCs are memorized in the tire pressure warning ECU and read by the tire pressure warning light blinking pattern or by using the Techstream (Click here).

  3. Test mode

    1. By switching from normal mode into test mode (input signal check), you can inspect the tire pressure warning antenna and receiver, each tire pressure warning valve and transmitter, and vehicle speed sensor (Click here).


CHECK WARNING LIGHT


    F100812E01
  1. Turn the power switch on (IG).

  2. Check that the tire pressure warning light illuminates for 3 seconds.
    If the warning check result is not normal, proceed to the troubleshooting for the tire pressure warning light circuit.
    Trouble Area
    See procedure
    Tire pressure warning light circuit
    Click here


TIRE PRESSURE WARNING LIGHT AND INDICATOR CHART

HINT:
The table below indicates the state of the tire pressure warning light and indicator after the power switch is turned on (IG).


Immediately after turning the power switch on (IG)
Always
Warning light output pattern
Comes on for 3 sec.
Goes off
Comes on
Blinks (*1) (Warning light flashes for 1 minute and then remains on)
Blinks (*2)
Blinks (*3)
Normal
○
○
-
-
-
-
Low tire pressure
○
-
○
-
-
-
System fail
○
-
-
○
-
-
Test mode
○
-
-
-
○
-
Initialization
○
-
-
-
-
○
ECU connector poorly connected
-
-
-
○
-
-
TC ground (DTC is output)
○
-
-
-
-
-
TC ground (DTC is not output)
○
-
-
-
-
-


  1. E133091E01
    *1: Comes on and goes off repeatedly at 0.5 second intervals, and comes on after 1 minute.

  2. C110635E06
    *2: Comes on and goes off repeatedly at 0.125 second intervals.

  3. C110636E04
    *3: Blinks 3 times (1 second on, 1 second off).